Bedienungsanleitung Black Decker GTC18452PC (Seite 8 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

665777

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

ENGLISH

(Original instructions)

To install battery pack

u Insert battery (8) into tool until an audible click is heard

(Figure. B)

u Ensure battery pack is fully seated and fully latched into

position.

To remove battery pack

u Depress the battery release button as shown in gure C

and pull battery pack out of tool.

Assembly instructions

Warning! Make certain the battery is removed before assem-

bly or disassembly of any parts.

Assembly tools required (not supplied):- phillips screw-

driver.

Attaching guard and bail handle to trimmer

Warning! Only use with handle and guard properly assembled

to hedge trimmer. The use of the hedge trimmer without

the proper guard or handle provided may result in serious

personal injury.

The trimmer is shipped with the guard and bail handle at-

tached with a plastic zip tie.

To assemble to trimmer:

u Cut the plastic zip tie.

u Remove the six screws that are partially run into the trim-

mer housing (Figure D).

u Slide the guard (5) onto the front of the trimmer housing

as shown in gure E

u Insert two of the six screws into the openings on the sides

of the guard and tighten securely.

u Slide the bail handle (6) onto the front of the trimmer hous-

ing behind the guard as shown in gure F.

u Insert the remaining four screws into the openings on the

sides of the bail handle and tighten securely.

Operation

u To turn the unit on, push the lock off button (2) down,

squeeze the trigger (1) and depress the dual switch bail

handle(6), as shown in gure G. Once the unit is running,

you may release the lock-off button. In order to keep the

unit running you must continue to squeeze the trigger.

Warning! Never attempt to lock a switch in the on position.

Trimming Instructions

u Maintain proper footing and balance and do not overreach.

Wear safety goggles, non-skid footwear when trimming.

Hold the unit rmly in both hands and turn the unit ON.

Always hold the trimmer, as shown in the illustrations in

this manual, with one hand on the switch handle and one

hand on the bail handle (gure H). Never hold the unit by

the blade guard.

Trimming new growth (Fig. I)

u A wide, sweeping motion, feeding the blade teeth through

the twigs is most effective. A slight downward tilt of the

blade, in the direction of motion gives the best cutting.

Warning! Do not cut stems greater than 19mm.

Use the trimmer only for cutting normal shrubbery around

houses and buildings.

Level hedges (Fig. J)

u To obtain exceptionally level hedges a piece of string can

be stretched along the length of the hedge as a guide.

Side trimming hedges (Fig. K)

u Hold the trimmer as shown and begin at the bottom and

sweep up.

POWERCOMMAND

If you encounter a jam, depress the POWERCOMMAND

button (4) shown in gure l. The blades will move back and

forth in a slower, more forceful rhythm to help cut through dif-

cult branches. Release the button to return to normal hedge

trimming usage.

Note: Once the button is released, the blades will immediately

return to full speed.

Note: The blades will stop when the button is held for 15 sec-

onds. To reengage the POWERCOMMAND feature, release

the button and depress it again. DO NOT continuously hold

the POWERCOMMAND button during normal hedge trimming.

Maintenance

Your BLACK+DECKER corded/cordless appliance/tool has

been designed to operate over a long period of time with a

minimum of maintenance. Continuous satisfactory operation

depends upon proper tool care and regular cleaning.

Warning! Before performing any maintenance on corded/

cordless power tools:

u Switch off and unplug the appliance/tool.

u Or switch off and remove the battery from the appliance/

tool if the appliance/tool has a separate battery pack.

u Or run the battery down completely if it is integral and then

switch off.

u Unplug the charger before cleaning it. Your charger does

not require any maintenance apart from regular cleaning.

u Regularly clean the ventilation slots in your appliance/tool/

charger using a soft brush or dry cloth.

u Regularly clean the motor housing using a damp cloth. Do

not use any abrasive or solvent-based cleaner.

u After use, carefully clean the blades. After cleaning, apply

a lm of light machine oil to prevent the blades from rust-

ing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GTC18452PC Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info