Bedienungsanleitung Bose SoundLink Micro (Seite 3 von 34) (Englisch)

704820

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

ENGLISH - 3

REGULATORY AND LEGAL INFORMATION

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by Bose Corporation could void the user’s authority to operate

this equipment.

This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s). Operation

is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

This device complies with FCC and ISED Canada radiation exposure limits set forth for general population.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Meets IMDA Requirements.

Product Power State Table

The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC and

the Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020, is in

compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008, as amended by Regulation (EU)

No. 801/2013.

Required Power State Information

Power Modes

Standby Networked Standby

Power consumption in speciﬁed power mode, at

230V/50Hz input

≤ 0.5 W Bluetooth® ≤ 2.0 W

Time after which equipment is automatically

switched into mode

≤ 10 minutes ≤ 10 minutes

Power consumption in networked standby if all wired

network ports are connected and all wireless network

ports are activated, at 230V/50Hz input

N/A ≤ 2.0 W

Network port deactivation/activation procedures.

Deactivating all networks will enable standby mode.

Bluetooth®: Deactivate by clearing the pairing list by pressing and

holding the Bluetooth® button for 10 seconds. Activate by pairing with a

Bluetooth® source.

For Europe:

Frequency band of operation 2400 to 2483.5 MHz.

Maximum transmit power less than 20 dBm EIRP.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bose SoundLink Micro Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bose SoundLink Micro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info