Setting up
Follow these steps to get your
Relate 600 ready for use.
Check that your Relate 600 is complete.
When you unpack you should have:
• Relate 600 telephone with telephone line cord
attached.
• Bracket for wall mounting.
• 2 screws and wallplugs.
1 Plug your Relate 600 into the BT socket
2 Set the ringer volume
The ringer switch is located on the underside of the
unit. There are 3 settings:
HI a loud ring; your Relate 600
is pre-set to this position.
LOW a quiet ring.
OFF no ring – if you don’t want to be disturbed.
Your Relate 600 is now ready for use.
3 Wall mounting your Relate 600 (optional)
Your Relate 600 can be wall mounted by using the
bracket provided. Use the wall bracket provided to
mark the position of the screws. (Drill size 8mm).
Handset clip
To rest the handset when the
Relate 600 is wall mounted.
Twist and turn it until it locks
into place.
How to use your
Relate 600
Using the memory to store and dial Friends
& Family numbers
You can store up to 10 of your most important, or
regularly used numbers, and then dial them by
pressing just one button for each.
Important: Before you use your Relate 600
Plan the location of the telephone. The following point
should be considered.
• The Relate 600 should be within two metres of the phone
socket. A new-style phone socket is needed.
If you do not have a new-style socket, call Freefone 0800
800 150 and ask for a BT engineer to come and fit the
correct socket. This is a chargeable service.
(The numbers can each be up to 32 digits long).
• Remove the memory label and pick up the handset.
• The first
ARROW indicator will glow, to indicate
the start of the memory storing sequence, the
LCD display will show three short lines.
• Press button A (a single ‘beep’ will be heard).
• The second
ARROW indicator will glow, informing
you to select one of the ten memory buttons, the
LCD display will be blank.
• Press one of the memory buttons
1-10, if the
memory location has a number in it, this will
appear on the
LCD display.
• The third
ARROW indicator will glow, informing you
to key in the number you want to store.
• Key in the telephone number you want to store,
this will be displayed on the
LCD. If there is a
number in the memory location the new number
will over write it.
• The fourth
ARROW indicator will glow, informing
you to confirm your selection, the
LCD will display
the number for 10 seconds.
• Press button
B to confirm (two ‘beeps’ will be heard).
The fifth and first
ARROW indicators will glow
alternately, instructing you to make a choice.
• Press button
C to inform BT of the number to
qualify for your Friends and Family discount, the
LCD will display the number of the friends
and family service.
• Write the name of the person whose number you
have just stored (if you use pencil, you can easily
change it in the future) in the appropriate space on
the memory label.
or
• Press button A to continue to store up to nine other
numbers in the memory buttons. Remember to
use a different memory button each time a number
is stored. The
ARROW indicators will glow to lead
you through the memory store sequence.
To dial numbers stored in the memory
• Pick up the handset.
• Press the
MEMORY button of the number you
wish to call.
• Relate 600 will dial the number automatically.
Note: Instructions are revealed when directory label
is removed.
If your phone is unplugged from its socket, the memory will
hold the stored numbers for 5 minutes. If unplugged for
more than 5 minutes, the numbers may be lost and you will
need to re-programme.
(Have your account number ready for reference; this is
available on your phone bill.)
