697447
69
Zoom out
Zoom in
Vorherige Seite
1/72
Nächste Seite
5
Operating and fault displays
MCM10
69
3 Operation: switching
contact not activated;
not a fault.
Fault: no boiler
operational.
Remove faults at the
boiler.
Fault: switching
contact activated, but
no power supply.
Check power supply.
Replace
MCM10 module.
Fault: flow
temperature sensor
faulty.
Check temperature
sensor on the MCM10
master and
connecting lead.
Replace
MCM10 module.
Fault: system
pressure too low.
Top up the system
with water.
Fault: no
communication
between
MCM10 module and
all connected boilers
for at least 1 minute.
Check corresponding
cables/leads.
Replace
MCM10 module.
4 Operation: no
communication
between 2 MCM10
modules or the
heating controller
(2-wire BUS).
Standard operating
mode with only one
MCM10 module or
with the MCM10
master without 2-wire
BUS controller.
Operation:
communication
between this MCM10
module and the
previous module or
the heating controller
(2-wire BUS).
Configuration:
communication
between 2 MCM10
modules or the
heating controller
(2-wire BUS).
Wait until the
configuration has
completed. The LED
will then be illuminated
steadily.
Fault: no
communication
between 2 MCM10
modules or the
heating controller
(2-wire BUS).
Check the
corresponding
connecting lead/
cable.
Replace MCM10
module or heating
controller.
Fault: no
communication
between 2 MCM10
modules or the
heating controller
(2-wire BUS),
although this
component is still
present.
Check the
corresponding
connecting lead/
cable.
Replace MCM10
module or heating
controller.
Fault: no
communication
between 2 MCM10
modules or the
heating controller
(2-wire BUS) because
this component has
been deliberately
removed.
Carry out
configuration reset
(Æ chapter 4.3).
LED Off On Flashing
No. Diagnosis Remedy Diagnosis Remedy Diagnosis Remedy
Tab. 10 Operating and fault displays
69

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Buderus MCM10 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info