632528
3
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
I. Hardware Bag Contents & Tool List
IMPORTANT: Please verify that you have received all of the contents
listed. Do not proceed with assembly if any parts are missing;
contact Burley immediately for replacement parts.
HARDWARE BAG CONTENTS
Parts
(1) Tongue & hitch assembly
(2) Wheel
(1) Two-piece safety flag
Envelope
Trailer checklist (outside of envelope)
Warranty card
Burley-Cub Owner’s Instruction & Safety Manual
Remove the wheels, tongue and hitch, safety flag, and envelope from
the inside of your Burley-Cub. Try to do all initial assembly with the
trailer on a clean sturdy table or work bench to make handling the
trailer easiest and to keep the fabric clean. If you must work on a
rough or dirty surface instead, be sure to lay down a cloth or the
flattened shipping carton to avoid damage to the trailer.
II. Attaching the Wheels
First, verify that the tires are inflated to 30-35 P.S.I. Next, tip the
trailer frame on its back end. If you are working on a rough or dirty
surface, lay down a cloth or other protective barrier to avoid damage
to your trailer. With the quick-release lever in the "OPEN" position,
insert the wheel axle assembly completely into the hollow trailer
axle, making sure that the horizontal shaft goes all the way into
the axle.
3
Quick-release
lever in unlocked
"OPEN" position
Quick-release
lever in locked
"CLOSED"
position
Wheel axle assembly inserts into
hollow trailer axle
XI. Parts List & Drawing
Note: Subassemblies are indented; inquire for additional parts
1. (1) Polyethylene Shell
2. (2) Front Reflector (Clear)
3. (2) Rear Reflector (Red)
4. (2) Suspension Elastomer
5. (1) Pair Side Panel Hold Down (Left & Right)
6. (1) Tongue Retaining Pin
7. (1) Pair Tongue Receptacle (Front & Rear)
8. (1) Safety Pin & Tether
9. (1) Front Roll Bar, 7/8" Aluminum Tube
10. (1) Roll-Bar Handle Assembly
11. (2) Front Roll-Bar Hinge (Plastic)
12. (1) Rear Roll Bar, 7/8" Aluminum Tube
13. (2) Rear Roll-Bar Hinge (Plastic)
14. (2) Roll-Bar Saddle (Plastic)
15. (1) Tongue & Hitch Assembly
16. (1) Tongue, 1 1/8" Square Aluminum
17. (1) Hitch with Hitch Knob & Ball
18. (1) Hitch Safety Strap
19. (1) Clip & D-Ring
20. (1) Rubber Flex Connector (Not Available Without Hitch)
21. (1) Pair Fabric Side-Panel Assembly, with Vinyl Windows
22. (1) Seat Pad
23. (1) Hold Down Strip, Seat Back & Pad
24. (1) Flow-Thru Seat Back with Harness
25. (4) Shoulder Strap
26. (3) Crotch Strap
27. (1) Lap Belt
28. (1) Buckle for Lap Belt
29. (2) Plastic Wheel, Each with (2) Wheel Bearing
30. (2) Wheel Reflector (Clear) with Self-Tapping Screw
31. (1) Swing Arm Assembly
32. (2) Hollow Axle
33. (2) Wheel Axle Assembly
34. (2) Quick-Release Lever
35. (1) Two-Piece Safety Flag
36. (1) Wide Screen 2-in-1 Cover
Options (at additional cost):
Walk ’n Roller Stroller Kit (not shown)
Alloy-Wheel Option
22
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Burley Cub 1996-2003 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info