632516
4
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
III. Installing the Quick-Release Levers
In the bag with the reflectors you’ll find two quick-release levers.
Install these through the hollow axle of the wheel. Make sure the
lever is on the flat side of the wheel, the thumb nut is on the deep-
dished side, and the springs are mounted on each side as shown in
the illustration below.
The quick-release lever
must be on flat side of
wheel and thumb nut on
deep-dished side. This
ensures that the lever
will be on the outside
when wheel is properly
installed.
Quick
Release
Lever
FlatDeep Dish
Thumb Nut
IV. Attaching the Wheels
First, verify that the tires are inflated to 30–35 P.S.I. Next, tip the
trailer frame on its back end. If you are working on a rough or dirty
surface, lay down a cloth or other protective barrier to avoid damage
to your trailer. Move the quick-release lever to the unlocked position
and place the wheels into the dropouts, making certain that the
axles go all the way into the slots.
The quick-
release lever
and flat side of
wheel must be
installed toward
outside of trailer.
Correct Wrong
4
XII. Safety Checklists
Before Each Ride, Ensure the Following:
Wheels tightly attached
Tire pressure 30–35 P.S.I.
Hitch properly secured with safety strap in place
Locked safety pins for tongue and roll bar
Maximum load 100 lbs.
Bicycle safety check, especially brakes and tires
Helmets for children & rider
Safety flag in place
Both seat buckles in rear of seat are securely fastened
Monthly Checklist
Inspect tongue and hitch for damage, scratches, or loose fasteners
Inspect tongue pivot for smooth operation: tongue should fold and
unfold freely; lubricate brass bushing if necessary
Inspect frame tubing and hardware for cracks, damage, or loose parts
Inspect tires; worn out or cracked tires can lead to blowout
Inspect wheels for trueness and cracks
Inspect wheel bearings for wear
Inspect fabric canopy, child seat, and harness for rips, abrasion, or
missing/damaged hardware
Contact authorized Burley dealer for repairs/replacement of any
damaged or worn out parts
IMPORTANT: Refer to section “X. Trailer Maintenance and Care” of this
manual for additional periodic maintenance. Unless you are a qualified
bicycle mechanic, contact your Burley dealer for repairs and maintenance.
21
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Burley D-lite 1996-2003 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info