Bedienungsanleitung Cadac 6530H1 - Camp Chef HP (Seite 3 von 7) (Englisch)

684179

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

• If there is a leak on your appliance (smell of gas), close the appliance valve immediately, and take it into a  ame free location where the leak

may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a  ame; use

soapy water.

• The correct way is to smear the joints e.g. where the cartridge screws onto the

appliance, with soapy water.

• If bubbles form, then there is a gas leak. Immediately remove the gas cartridge

from the appliance. Check that all the connections are properly  tted. Check that

the seal is in place and in good condition before connecting a gas cartridge(Fig.

4b). Re-check with soapy water after re tting the cartridge.

• If a gas leak persists, return the product to your CADAC dealer for inspection /

repair.

• Use Outdoors Only.

Fig. 2

Fig. 1

3. Assembly Instructions

• WARNING: The legs are spring loaded. Opening and closing of the legs must

be done in a controlled manner to avoid personal injury or damage to your

Camp Chef.

• To open the legs, turn the unit upside-down and hold the legs down while lifting

each leg individually. You will hear a “click“ if the leg(s) has located correctly.

• To fold the legs back, securely hold the leg and push the Leg Release Clip down.

Then push the legs in-ward to its closed position (Fig 5). This needs to be done

sequentially to optimise space. First the Right front leg (1), Then the

Left front leg (2), and lastly the rear Leg (3) (Fig 3b).

• Before connecting the gas supply,  rstly check that the appliance valve is in the off

position by turning the control knob

fully clockwise (See Fig. 1).

• To  t the Gas Container,  rst check

that the appliance valve is in the off

position by turning the control knob

clockwise to its stop (See Fig. 1).

Making sure that the Gas Container

is kept upright, screw the container

onto the valve in a clockwise

direction until it is fully engaged,

hand-tighten only. If the container

is over-tightened, it may damage the

container valve.

• Your appliance is now ready for use.

Fig. 4a

Fig. 3a

Fig. 3b Fig. 3c

4. Fitting and Changing the Gas Supply

• Check that the burner is extinguished before disconnecting the gas container.

• To disconnect the gas container unscrew the container from the valve. (See Fig 4a)

• Check the Seal before replacing the gas container.

• Change the gas container outdoors and away from other people.

• To re t a previously used gas container, refer to instructions in Section 3 above. Apply the same care and checking procedures as if  tting a

new gas container.

Fig. 4a

Seal

Fig. 4b

503-0574 LEV7 - (6530H0, 6530H1) Camp Chef HP - User Manual (EU + SA).indd 2 15/03/2016 11:57:43

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadac 6530H1 - Camp Chef HP Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 6530H1 - Camp Chef HP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info