699206
4
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
RMD 801DAB-BT MANUAL
2
SAFETY PRECAUTIONS
Important Warnings to Take Note of BEFORE Commencing Installation
Damage Caused By Incorrect Installation or Usage is NOT Covered By Warranty.
PLEASE Take the Time to Read the Installation Notes Carefully.
To Validate the Warranty Please Ensure That the Unit is Installed by a Professional, VAT registered
Car Audio Installation Company.
To avoid short in your vehicles electrical system, be sure to disconnect the battery cable before beginning installation.
The unit is intended for vehicles with a 12-volt battery and negative grounding. Before installing the unit in a recreational vehicle,
truck, or bus, check that the battery voltage is 12 volts.
Remove the two transport screws from the top of the unit before installation.
The black lead is ground. A good chassis ground requires a tight connection to ground. The area should be free from rust, paint or
any form of dirt. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the
products together and the ground becomes detached, there is a risk of damage to the products or fire.
Be sure to connect the colour coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or
damage the vehicle’s electrical system. Cords for this product and those for other products may be different colours even if they have
the same function. When connecting this product to another product, refer to the supplied installation manuals of both products and
connect cords that have the same function.
Be sure to connect the negative (-) speaker leads to the negative (-) speaker terminal. Never connect the negative (-) speaker leads
to chassis ground.
This unit is only designed for use with 4 speakers. Do not combine outputs for use with 2 speakers. Do not ground negative speaker
leads to the chassis ground.
Speakers connected to this unit must be high-power units with a minimum rating of 45W and impedance of 4 to 8 ohms. Connecting
speakers with output and/or impedance values other than those noted there will result in damage to the head unit and the speakers.
Check the condition off your speakers carefully - connecting the unit to old of degraded speakers may result in a fault which
will damage the audio IC and invalidate the warranty.
If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should
be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained
when you are away from the vehicle for several hours.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Caliber RMD801DAB-BT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Caliber RMD801DAB-BT

Caliber RMD801DAB-BT Kurzanleitung - Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info