Use front feet to level the machine with the floor.
Rotate foot to raise or lower it until it stands firmly on the
ground.
Ensure that the Off/On button (C) is not pressed.
Ensure that all the knobs are on the “0” position and that the
door is closed.
Insert the plug.
After installation, the appliance must be positioned so that
the plug is accessible.
Press the START (C) button. The power on (N) light will light up.
If this does not light up see faults search.
Fix the sheet of corrugated material on the bottom as shown
in picture.
Connect the fill hose to the tap.
The appliance must be connected to the water mains using
new hose-sets. The old hose-sets should not be reused.
IMPORTANT:
DO NOT TURN THE TAP ON AT THIS TIME.
Position the washing machine next to the wall. Hook the
outlet tube to the edge of the bath tub, paying attention
that there are no bends or contractions along the tube.
It is better to connect the discharge hose to a fixed outlet of
a diameter greater than that of the outlet tube and at a
height of min. 50 cm. If is necessary to use the plastic sleeve
supplied.
EN
36
EN
37
