Bedienungsanleitung Cateye CC-GL50 (Seite 37 von 41) (Englisch)

538691

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

Introduction

How to install the

unit on your bicycle

Setting up the

computer

How to use the

computer

Setup of your PC

Uploading the

measurement data

Changing the

computer

conﬁguration

Others

Trouble Check Items Remedy

MEM FULL ﬂashes. Does the maximum re-

cording time or the num-

ber of trips exceed the

upper limit?

* For details, see “Record

interval and capacity

limit” (page 23)

Connect the computer to your PC

to upload the trip data (page 20).

All the trip data transferred to your

PC will be deleted from the com-

puter, and new data will be able to

be recorded.

Does the maximum time

for one trip exceed the up-

per limit?

* For details, see “Record

interval and capacity

limit” (page 23)

Perform the resetting operation

(page 16) to stop the current trip.

Then, you can record as another

trip.

The backlight does not

light up even at the

preset hour.

Are the start time and end

time set to the same hour?

The backlight does not light up

when the start time and end time

are set to the same hour.

For information on how to set the

start/end time, see “Changing the

computer conﬁguration” (page 27).

Is the start time of the

night-time set correctly?

For information on how to set the

start time, see “Changing the com-

puter conﬁguration” (page 27).

The backlight lights up

during the daytime.

Troubles related to the ANT+ sensor

Refer to the following information when the optional or commercial ANT+ sensor is used.

* Pairing with the computer is required in order to use the ANT+ sensor. For details, see

“Pairing the sensor” (page 32).

* When a commercial ANT+ sensor is used, also refer to the instruction manual supplied

with your sensor.

Trouble Check Items Remedy

The heart rate can-

not be measured (

does not ﬂash).

Did you perform pairing

with the heart rate sensor?

Perform pairing (page 32).

Is the electrode pad de-

tached from your body?

Wear the electrode pad appropri-

ately so that it is in close contact

with the body.

Is your skin dry? Moisten the electrode pad a little.

Is the electrode pad overly

worn and damaged after

long use?

Replace with a new one.

Is the battery for the heart

rate sensor used up?

Replace with new batteries.

The heart rate mea-

surement is not con-

stant (measurement is

performd at times, or

reset to 0).

Is the heart rate sensor

attached correctly?

Attach the heart rate sensor in the

correct position by referring to the

relevant instruction manual.

The power cannot be

measured (

P does

not ﬂash).

Did you perform pairing

with the power sensor

used?

Perform pairing (page 32).

Is the condition for

mounting the power sen-

sor cleared?

Mount the power sensor correctly

by referring to the relevant instruc-

tion manual.

Is the battery for the

power sensor used up?

Replace with new batteries.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cateye CC-GL50 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cateye CC-GL50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info