Bedienungsanleitung Cobra MX515SPBI - DYM1588SD (Seite 13 von 19) (Englisch)

634408

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

- 13 -

underside of the deck preventing proper mowing of the grass clippings. Cut no more than 1/3 the length of the grass. The

recommended cut for mowing is 1/3 the length of the grass. Ground speed will need to be adjusted so the clippings can be

dispersed evenly into the lawn. For especially heavy cutting in thick grass it may be necessary to use one of the slowest speeds

in order to get a clean well mowed cut. When mowing long grass you may have to cut the lawn in two passes, lowering the blade

another 1/3 of the length for the second cut and perhaps cutting in a different pattern than was used the first time. Overlapping

the cut a little on each pass will also help to clean up any stray clippings left on the lawn. The mower should always be operated

at full throttle to get the best cut and allow it to do the most effective job of mowing. Clean the underside of deck. Be certain to

clean the underside of the cutting deck after each use to avoid a build-up of grass, which would prevent proper mulching. Mowing

leaves. The mowing of leaves can also be beneficial to your lawn. When mowing leaves make sure they are dry and are not

laying too thick on the lawn. Do not wait for all the leaves to be off the trees before you mow.

WARNING: if you strike a foreign object, stop the engine. Remove wire from spark plug, thoroughly inspect the mower for

any damage and repair the damage before restarting and operating the mower. Extensive vibration of the mower during

operation is an indication of damage. The unit should be promptly inspected and repaired.

7.7 GRASS CATCHER

Fig. 11

7.8 DECK

The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings, leaves, dirt or other

matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent proper mulching.The deck may be

cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug wire is disconnected).

7.9 HEIGHT ADJUSTMENT INSTRUCTIONS

CAUTION: Do not at any time make any adjustment to lawnmower without first stopping the engine and disconnecting the

spark plug wire.

CAUTION: before changing mowing height, stop mower and disconnect spark plug cable.

Your mower is equipped with a central height adjustment lever offering 5 height positions.

Fig.12

1. Stop mower and disconnect spark plug cable before changing mower cutting height.

2. The central height adjustment lever offers you 5 different height positions.

3. To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down to selected height. (Fig.12)

All wheels will be in the same height of cut.

There is a window on the rear cover. You can see the condition of grass catcher

through the window. If the catcher is full of grass, you will empty and clean the

bag, make sure it is clean and ensure its meshwork is ventilated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cobra MX515SPBI - DYM1588SD Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info