Bedienungsanleitung Danfoss TP5E (Seite 2 von 4) (Englisch)

465521

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

NOTE

While in programming mode (but not in time setting), if no

buttons are pressed for 2 to 3 minutes the TP5E

automatically returns to RUN mode, and the programme

set up to that moment will be active. This programme may

not be the one intended so review the settings again,

before returning to RUN by pressing PROG at setting 6,

days 6 & 7.

EVERYDAY OPERATION

When all twelve time/temperature

settings have been checked and/or

altered, ensure the TP5E is in the RUN

mode, with the colon blinking, (see fig.

7), before sliding the cover shut.

TIME OR TEMPERATURE DISPLAY

The TP5E will always display the time

and required temperature after a

RESET. Once the switching times and

temperatures have been set and the

unit returned to the RUN mode, the

actual room temperature can be displayed instead of the

time. To change between time and temperature display

press the + and - buttons together. Fig. 8 is a typical

temperature display showing the actual temperature, the

required temperature, and flame and thermometer

symbols. The flame symbol appears in either time or

temperature displays when the TP5E is calling for heat.

MANUAL OVER-RIDE

The programmed control temperature

may be changed temporarily using the

s and t buttons until the required

temperature is shown. An s or t

arrow will appear in the display as a

reminder that the programmed setting has been over-

ridden, (see fig. 8 again). This over-ride is cancelled at

the next programmed switching.

WEEKEND into WEEKDAY OVER-RIDE

To use days 6 & 7 settings during any of days 1 to 5 press

the s and t buttons together, (see fig. 9). This over-ride

is cancelled by selecting Constant Temperature Control

(see below) or when the time reaches 2:00.

CONSTANT TEMPERATURE OVER-RIDE

To set the TP5E to control at a constant temperature of

5°C press the s and t buttons together, once from

Weekend/Weekday over-ride or twice from RUN mode.

The required constant temperature

may now be set using the s and t

buttons, and can be anywhere in the

range 5°C to 30°C. At 5°C a snowflake

symbol appears in the display (see fig.

10) indicating frost protection mode*;

at all other temperatures an s arrow

appears (see fig. 11) indicating a

constant temperature selection. This

over-ride is cancelled by pressing the

s and t buttons together.

*NOTE

The TP5E will only provide frost protection to the area in

which it is fitted. It WILL NOT provide frost protection in

unheated areas, and may not provide frost protection in

heated areas not controlled directly by the TP5E.

BATTERY REPLACEMENT

When the batteries approach the end

of their life, a battery symbol blinks in

the display (see fig. 12). When this

symbol appears both batteries should

be replaced with high quality alkaline

cells. 15 days after the symbol appears the TP5E will

switch off. While the battery symbol is blinking the batteries

may be changed without loss of time or programme.

Have the new batteries unwrapped and ready, slide the

battery cover fully off to the left, remove the old batteries

and fit the new ones WITHIN FIVE MINUTES. Replace

and close the battery cover. The TP5E will continue to

function according to the automatic programme. Should

the display ever become blank during normal operation

the batteries will have to be renewed, the unit RESET,

and the time, day and programme re-set as required.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Danfoss TP5E Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Danfoss TP5E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info