Bedienungsanleitung De Dietrich DCM 390 XE1 (Seite 4 von 6) (Englisch)

34552

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

4 9

Installing your appliance in all simplicity Use of the grill

Setting

To set, press and release the desired function, and within 5 seconds

set the time with + and - buttons.

+ and - buttons.

The + and - buttons increase or decrease the time at a speed

depending on how long the button is pressed.

Setting the time

Press any two buttons (cooking time, end time, minutes counter)

at the same time, and + or - button to set the desired time. This

deletes any previously set programme. The contacts are switched

off and the AUTO symbol flashes.

Manual use

By pressing the manual button the relay contacts switch on, the

AUTO symbol switches off and the saucepan symbol lights up.

Manual operation can only be enabled after the automatic

programme is over or it has been cancelled.

Automatic use

Press the cooking time or end time button to switch automatically

from the manual to the automatic function.

Semi-automatic use with cooking time setting

Press the cooking time button and set the desired time with + or

-. The AUTO and cooking time symbols light up continuously. The

relay switches on immediately. When the cooking end time

corresponds to the time of day, the relay and cooking time symbol

switch off, the sound signal rings and the AUTO symbol flashes.

Semi-automatic use with end time setting

Press the end time button. The time of day appears on the display.

Set the cooking end time with + button. The AUTO and cooking

time symbols light up continuously. The relay contacts switch on.

When the cooking end time corresponds to the time of day, the

relay and the cooking time symbol switch off. When the cooking

time is up, the AUTO symbol flashes, the sound signal rings and

both the relay and the cooking time button switch off.

INSTRUCTION FOR USE OF CONTROL DEVICE

Minute timer

Cooking time

Cooking end

Manual

Subtract time

Add time

The cooker is fitted with 4 legs for an eventual alignment in height

with the furniture ( fig.1).

WARNINGS

The technical data are indicated on the data nameplate placed

on the rear of the appliance.

The adjustment conditions are stated on the label applied on the

packaging and on the appliance.

Do not use the oven door handle to move the appliance, such as

to remove it from the packaging.

The appliance is in class 1 or class 2 subclass 1.

INSTALLATION

IMPORTANT: The coating of the furniture must be able to withstand

high temperatures (min. 90°C).

If the appliance is to be installed near units, leave the minimum

gaps specified in the table below.

Location

Your cooker is heavy, so be careful when moving or positioning

it. Do not try to move the cooker by pulling on the doors, handles

or control panel. The cooker is designed to “slot in” between

600mm deep cabinets, spaced approximately 1000mm apart. It

can also be used free-standing, with a cabinet to one side, in a

corner setting or with its back to a wall. However, it must not be

situated with either side closer than 20mm to a combustible wall

or cupboard that is higher than the cooker.

In case of installation between kitchen units, their sides must

withstand a temperature of at least 90 degrees C.

The wall behind the cooker and 450mm above and across the

width of the cooker, should be an incombustible material or easy

clean surface such as ceramic tiles.

Any overhanging surface or cooker hood should be at least 750mm

(30”) above the cooker hob. We do not recommend positioning

the cooker below wall cupboards, as the heat and steam from the

cooker may cause damage to the cupboard and its contents.

The cooker may be located in a kitchen, or a bed-sitting room,

but not in a room containing a bath or shower. The cooker must

not be installed in a bed-sitting room of less than 20m

LPG Models must not be installed in a room or internal space

below ground level, e.g. in a basement.

Install the grid on the third shel from the oven bottom, at about

12 cm from the surface.

The user can change the shelves, depending on his personal

whishes and on the different food.

Turn on the oven 5 minutes before introducing the food.

TURNSPIT

- Put the food in spit L, paying attention to block it within the two

forks F and to balance it, in order to avoid any unnecessary effort

in motor R (fig 7).

- Put the spit on support G, after having put its opposite end into

hole P of motor R.

- Place the drip-tray with a little water under the spit.

- Fit the knobs deflector S (see fig. 7) and place the door in half-

open position as in (see fig. 6).

- To remote the spit, operate in the opposite direction using knob

A and protecting glove in isolating wool (see fig. 7).

Fig. 6

Fig. 7

Features

24 hours clock with automatic programme and minutes counter.

Functions

Cooking time, cooking end time, manual position, clock,

minutes counter, times to be set up to 23 hours 59 minutes.

Display

4-figures, 7-segments diplay for cooking times and time of day.

Cooking time and manual function = saucepan symbol

Automatic function = AUTO

Minutes counter = bell symbol

The symbols light up when the corresponding functions are

selected.

min. 20mm

min.100 mm

min. 50 mm min. 50 mm

min. 650 mm

min. 400 mm

min. 20mm

1000

935

600

110

875

Fig. 1

Régulation.

max. 15mm

For the turnspit motor operation, turn the knob on the

symbol .

De Dietrich DCM 390 XE1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info