Bedienungsanleitung DeLonghi ECAM45.760 Eletta Cappuccino (Seite 18 von 20) (Englisch)

800465

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

131

3. Press < (B4) or > (B8-g. 9) until “Install lter, Enabled” is

displayed;

4. Press the OK button (B12- g. 10);

5. “Disable?” appears on the display;

6. Press the OK button to conrm and the MENU/ESC button

to exit the menu.

16. TECHNICAL DATA

Voltage: 220-240 V~ 50/60 Hz max. 10 A

Power: 1450 W

Pressure: 1,5 MPa (15 bar)

Water tank capacity: 2 L

Size LxDxH: 260x470x365 mm

Cord length: 1750 mm

Weight: 11 kg

Beans container capacity: 400 g

The appliance complies with the following EC

directives:

• European Standby Regulation 1275/2008

• Materials and accessories coming into contact with food

conform to EEC regulation 1935/2004.

17. DISPOSAL

The appliance must not be disposed of with house-

hold waste, but taken to an authorised waste separa-

tion and recycling centre

18. DISPLAYED MESSAGES

DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION

FILL TANK Insucient water in the tank (A16). Fill the tank with water and/or insert it cor-

rectly, pushing it as far as it will go until it

clicks into place.

EMPTY GROUNDS CONTAINER The grounds container (A10) is full.

Empty the grounds container and drip tray

(A12), clean and replace (g. 31). Important:

when removing the drip tray, the grounds

container (A10) MUST be emptied, even if it

contains few grounds. If this is not done, when

you make the next coees, the grounds contai-

ner may ll up more than expected and clog the

machine. If the problem persists, make sure the

water tank (A16) is fully inserted, press the

button (B7) and deliver a little water from the

spout (C6).

GROUND TOO FINE ADJUST

MILL

The grinding is too ne and the coee is delive-

red too slowly or not at all.

Repeat coee delivery and turn the grin-

ding adjustment dial (A5, g. 14) one click

clockwise towards “7” while the coee mill is

in operation. If after making at least 2 coees

delivery is still too slow, repeat the correction

procedure, turning the grinding adjustment

dial another click (section “9.5 Adjusting the

coee mill”).

If the water softener lter (C4) is present, an

air bubble may have been released inside the

circuit, obstructing delivery.

Insert the hot water spout (C6) in the appliance

and deliver a little water until the ow beco-

mes regular.

INSERT GROUNDS CONTAINER After cleaning, the grounds container has not

been replaced (A10).

Remove the drip tray (A12) and insert the

grounds container.

ADD PREGROUND COFFEE With the “pre-ground coee” function selected,

pre-ground coee has not been poured into the

funnel (A4).

Place pre-ground coee in the funnel or dese-

lect the “pre-ground” function (g. 18).

DESCALE The machine must be descaled. The descaling procedure described in section

“13. Descaling” needs to be performed as soon

as possible.

REDUCE COFFEE AMOUNT Too much coee has been used. Select a milder taste by pressing the

button (B2- g. 11) or reduce the quantity of

pre-ground coee.

FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (g. 15).

The pre-ground coee funnel (A4) is clogged. Empty the funnel with the help of the brush

(C5) as described in section “12.8 Cleaning the

pre-ground coee funnel”.

INSERT INFUSER ASSEMBLY The infuser has not been replaced after clea-

ning (A15).

Insert the infuser as described in section “12.9

Cleaning the infuser”.

INSERT TANK The tank (A6) is not correctly in place. Insert the tank correctly and press as far as it

will go.

GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,

as described in section “12. Cleaning”. If the

message is still displayed after cleaning, con-

tact a service centre.

EMPTY CIRCUIT FILL CIRCUIT

alternating with

HOT WATER

Press OK

The water circuit is empty Press OK (B12- g. 10) to deliver water from

the spout (C6) until it ows out normally. If the

problem persists, make sure the water tank

(A16) is fully inserted.

REPLACE FILTER The water softener lter (C4) is exhausted. Replace the lter or remove it as described in

section “15. Water softener lter”

SET DIAL TO CLEAN Milk has been delivered recently and the tubes

inside the milk container must be cleaned (D).

Turn the froth adjustment dial (D1) to the

CLEAN position.

INSERT WATER SPOUT The hot water spout (C6) is not inserted or is

inserted incorrectly

Insert water spout as far as it will go.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi ECAM45.760 Eletta Cappuccino Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM45.760 Eletta Cappuccino

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info