Bedienungsanleitung DeLonghi ECAM45.760 Eletta Cappuccino (Seite 19 von 20) (Englisch)

800465

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

132

PROBLEM POSSIBLE CAUSE SOLUTION

The coee is not hot. The cups were not preheated. • Enable the cup warmer (A6), leave the

cups at least 20 minutes to warm up.

• Warm the cups by rinsing them with hot

water (Please note: you can use the hot

water function).

The internal circuits have cooled down

because 2/3 minutes have elapsed

since the last coee was made.

Before making the coee, heat the infuser by

rinsing using the "rinse" function (see section

"8.1 Rinsing").

A low coee temperature is set.

Set a hotter coee temperature (see section

"8.10 Setting the temperature").

The coee is weak or not creamy

enough.

The coee is ground too coarsely. Turn the grinding adjustment dial (A5) one

click anticlockwise towards "1" while the cof-

fee mill is in operation (g. 14). Continue one

click at a time until coee delivery is satisfac-

tory. The eect is only visible after delivering

2 coees (see section "9.5 Adjusting the coee

mill").

The coee is unsuitable. Use pre-ground coee for espresso machines.

The coee is delivered too slowly or a

drop at a time.

The coee is ground too nely. Turn the grinding adjustment dial (A5) one

click clockwise towards "7" while the coee

mill is in operation (g. 14). Continue one click

at a time until coee delivery is satisfactory.

The eect is only visible after delivering 2

coees (see section "9.5 Adjusting the coee

mill").

Coee does not come out of one or

both of the spouts.

The coee spouts (A7) are blocked. Clean the spouts with a toothpick (see section

"12.7 Cleaning the coee spouts").

The appliance does not come on The power cord (C8) connector is not

inserted correctly.

Insert the connector as far as it will go in the

socket at the back of the appliance (A19- g.

1).

It is not plugged into the mains socket. Plug into the mains socket (g. 1).

The main switch (A20) is not turned on. Press the main switch (g. 2).

The infuser cannot be extracted The appliance has not been turned o

correctly

Turn the appliance o by pressing the but-

ton (B1) (section "7. Turning o").

19. TROUBLESHOOTING

Below is a list of some of the possible malfunctions.

If the problem cannot be resolved as described, contact Customer Services.

INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container (g. 24) as far as it

will go.

The milk does not

come out of the milk

spout (D5)

The milk container lid (D2) is dirty. Clean the milk container lid as described in sec-

tion "12.10 Cleaning the milk container"

The milk contains

large bubbles and

squirts out of the

milk spout (D5) or

there is little froth

The milk is not cold enough or is not

semi-skimmed.

Use skimmed or semi-skimmed milk at refrige-

rator temperature (about 5° C). If the result is

not as you wished, try changing brand of milk.

The froth adjustment dial (D1) is incor-

rectly adjusted.

Adjust following the instructions in section "10.

Making cappuccinos and milk-based coees".

The milk container lid (D2) or froth

adjustment dial (D1) are dirty.

Clean the milk container lid and dial as de-

scribed in section "12.10 Cleaning the milk

container".

The hot water/steam connection noz-

zle (A8) is dirty.

Clean the connection nozzle as described in

section "12.11 Cleaning the hot water/steam

connection nozzle".

The milk contains

large bubbles and

squirts out of the

milk spout or there is

little froth.

The spout (C6) is dirty. Clean as described in section "11.5 Cleaning

the spout after use"

20. ELECTRICAL REQUIREMENTS UK ONLY

Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt

about your supply contact your local electricity company.

The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.

Should this plug not t the socket outlets in your home, it should be cut o and replaced with a suitable plug, following the procedure outlined below.

Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might nd it and

plug it into a supply socket - with the obvious consequent danger.

N.B. We recommend the use of good quality plugs and wall sockets that can be switched o when the machine is not in use.

IMPORTANT: the wires in the mains lead tted to this appliance are coloured in accordance with the following code:

GREEN AND YELLOW EARTH

BLUE NEUTRAL

BROWN LIVE

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug,

proceed as follows:

- The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol

or coloured green or green and yellow.

- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug.

If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualied electrician.

Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualied electrician and should only be replaced

with a exible cord of the same size.

After replacement of a fuse in the plug, the fuse cover must be retted. If the fuse cover is lost, the plug must not be used until a replacement cover is

obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always

state this colour when ordering a replacement fuse cover.

Only 13amp replacement fuses which are asta approved to B.S. 1362 should be tted.

This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.

Warning - this appliance must be earthed

DeLonghi ECAM45.760 Eletta Cappuccino Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM45.760 Eletta Cappuccino

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info