Collection
25
3 INSTALLATION
• After unpacking, make sure the appliance is complete and undamaged. If in doubt, do not use it.
Contact professionally qualified personnel.
• The packing elements (plastic bags, polystyrene foam, etc.) should be kept out of the reach of children as
they are a safety hazard.
• Place the appliance on a work surface far away from water taps, basins and sources of heat.
• After positioning the appliance on the work top, leave a space of at least 5 cm between the surfaces
of the appliance and the side and rear walls and at least 20 cm above the coffee maker.
• Never install the appliance in environments where the temperature may reach 0 or lower (the
appliance may be damaged if the water freezes).
• Make sure the mains voltage corresponds to the voltage indicated on the appliance rating plate. Connect
the appliance to an efficiently earthed socket with a minimum current rating of 10A only.
The manufacturer may not be considered liable for possible incidents caused by the failure to adequately
earth the mains.
• IIf the power socket does not match the plug on the appliance, have the socket replaced with a suitable
type by a qualified professional.
• The power cable on this appliance must not be replaced by the user as this operation requires the use of
special tools.
If the cable is damaged or requires replacing, contact an authorised service centre only to avoid all risks.
• You should personalise water hardness as soon as possible following the instructions in section 17.6.
• Coffee has been used to factory test the appliance and it is therefore completely normal for there to be tra-
ces of coffee in the grinder. It is, however, guaranteed to be new.
To correctly learn how to use the appliance, when starting it for the first time, carefully follow the step-by-step
instructions described in the following paragraphs.
4 USING FOR THE FIRST TIME
1. The first time you use the appliance, select the language.
To set English, plug the appliance into the mains socket and wait for the following message to be displa-
yed:
PRESS OK TO INSTALL ENGLISH
While the message is displayed, press the OK button (fig. 1) for at least three seconds until you hear a BEEP
(fig. 1) and the display shows:
ENGLISH INSTALLED
The appliance then displays the setting message in English. If you select the wrong language by mistake,
follow the instructions in section 18 to choose the right one.
2. After 5 seconds, the appliance displays:
FILL TANK
To refill the tank, remove (fig. 2), rinse and fill it with fresh water. Never exceed the MAX line.
Put the tank back and push as far as it will go. The appliance now displays:
PRESS OK
3. Place a cup under the hot water spout (fig. 3).
4. Press the OK button (fig. 1) and a little water is run off from the spout.
5. The appliance displays:
TURNING OFF PLEASE WAIT
and it goes off.
6. Fill the container with coffee beans (fig. 5) taking care not to exceed the "MAX" line.
