Bedienungsanleitung Dobar 50132 (Seite 4 von 6) (Deutsch, Englisch)

716474

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Introduction

Be familiar with the product before using it for the rst time. Please read the follo-

wing operating instructions and the safety instructions carefully. Use the product only

as described and for the specied application areas. Keep these instructions. Hand

over all documents when passing the product on to third parties.

Intended Use

This product is only suitable for the feeding of pets for private use. The product is not

intended for commercial use.

General safety instructions

Damages caused by non-observance of these operating instructions will void the

guarantee claim! No liability is assumed for consequential damages! No liability is

accepted for damage to property or personal injury caused by improper handling or

neglecting the safety instructions!

Control Panel Keys

• MODE - switches between clock or feeding time display. Also increases clock

time during clock / feeding time Set mode

• SET – enters settings mode. Also conrms the time you enter and advances to

next setting

• START NOW – starts the feeding timer immediately

• START TOMORROW- starts the feeding timer the next day

• REC – records your personal voice message

• PLAY – plays back your recorded voice message

• ON SWITCH – turns the feeder on / o. For when the feeder will not be used

for an extended period of time. Turning this switch o will RESET all time and

feeding settings

Getting Started

1. Carefully turn the pet feeder upside down. Remove both battery doors by

squeezing the two tabs and gently pulling each door away

2. Keep the ON switch set to OFF

3. Insert four C size alkaline batteries into the battery tray. Do NOT use old or

-cheap- carbon batteries

4. Close the battery doors, rotate the feeder right-side up and switch ON

5. The feeder will cycle one time until “12:00” is on the LCD display

Note: Your pet feeder makes the food available in this sequence:

Tray 1, Tray 2, Tray 3 to Tray 6. When you want only one feeding, you

should ll only Tray 1; for only 2 feedings, ll Trays 1 and 2 and so

on.

Bell

Hours

Minutes

Start

Tomorrow

Setting the Feeding Time

1. After setting the clock time, press the MODE key one time. (1 1) will show on

the display. This is the feeding-time display mode.

2. Now press and hold the SET key for (2 seconds) to enter Feeding time SET

mode. Feeding will start from the rst feeding number & time. The 1st digit

shows the feeding number (Food Tray 1)

3. The hour digit will now blink (2nd and 3rd digit). Press the MODE key to increase

the time, then press the SET key to conrm the time you set

4. After conrming the 1st feeding time, the next feeding number & time will

show on the display. (1st digit will change to the next feeding number, e.g. 2 or

3 or 4 or 5 or 6 and back to 1) To change the feeding time, repeat step-3

5. Repeat step-3 until all 6 feeding times are set. The display will change back to

clock display mode when all 6 feedings have been set

Setting the Feeding Time

1. After setting the clock time, press the MODE key one time. (1 1) will show on

the display. This is the feeding-time display mode.

2. Now press and hold the SET key for (2 seconds) to enter Feeding time SET

mode. Feeding will start from the rst feeding number & time. The 1st digit

shows the feeding number (Food Tray 1)

3. The hour digit will now blink (2nd and 3rd digit). Press the MODE key to increase

the time, then press the SET key to conrm the time you set

4. After conrming the 1st feeding time, the next feeding number & time will

show on the display. (1st digit will change to the next feeding number, e.g. 2 or

3 or 4 or 5 or 6 and back to 1) To change the feeding time, repeat step-3

5. Repeat step-3 until all 6 feeding times are set. The display will change back to

clock display mode when all 6 feedings have been set

Program examples:

1. Feed once a day at 13:00hr (24hrs display) and feed for 6 days

Feed time 1 & 2 & 3 & 4 & 5 & 6 all equal = 13:00hr

2. Feed twice a day at 10:00 and 20:00 and feed for three days

Feed time 1 = 10, feed time 2 = 20, feed time 3 = 10, feed time 4 = 20, feed

time 5 = 10 and the last time 6 = 20

3. Feed three times a day at 6:00am, 12:00 and 18:00 (6:00pm)

Feed time 1 = 06, feed time 2 = 12, feed time 3 = 18 and so on…

digit

Feeding

Number

Feeding

Time

Review and Start the feeding timer

1. Use the MODE key to cycle through clock and your set feeding times.

2. Press the START NOW key to start the feeding timer immediately. The bowl will

rotate to the pre-set starting position (Tray 6) and your recorded message will

play once. The BELL icon will now be On

3. Or press the START TOMORROW key and the feeding timer will start at

0:00-Midnight. The bowl will rotate to the pre-set starting position (Tray 6) and

your recorded message will play once. The BELL and Zz icon will now be On

Quick Start Guide

50132 Automatic 6 Meal LCD Clock Pet Feeder

Start

Tomorrow

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dobar 50132 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info