Bedienungsanleitung Dobar 50132 (Seite 6 von 6) (Deutsch, Englisch)

716474

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Assembly (refer to diagram)

Lid-(A) – Place the slide cover on top of the food bowl so the nger tab is in the

opening of the lid. Now align lid pins with the feeder base and push down. The lid pins

only align one way on the feeder base. Do not use excessive force when installing the

lid. Check for proper alignment if you have trouble getting the lid to lock down on the

feeder base.

• SLIDE COVER (B) – For keeping your pet from eating until the 1st programmed

feeding starts.

• FINGER TAB (C) – For closing the slide cover which will lock into the lid

• FOOD BOWL (D) – The food bowl will seat into the hub in the feeder base in only

one position. Be sure the food bowl seats properly onto the hub

• HUB (E) – The food bowl slides into this and is what rotates the food bowl

• LOCK (F) – Used to lock the lid to the feeder base. Push in the middle of each lock

and pull up using your ngertips to remove lid.

• FEEDER BASE (G) – Place the feeder base on a at level surface at a height that is

easy for you to see what you are doing

Notes & FAQ

1. When the bowl is rotating both the clock setting and mode setting are not

allowed.

2. Under clock display mode the colon icon (:) will ash. The colon icon (:) is turned

O when in feeding timer mode.

3. A PM icon will be displayed in the afternoon under 12-hour clock mode and

turned o in the AM. The PM icon will not be displayed under 24 hour clock

mode.

4. In feeding timer mode, three numbers will show up, the rst number is the

feeding number (1, 2, 3, 4, 5 or 6) and last two digits indicate the feeding time

in hours.

5. When the feeding timer starts, the BELL icon will turn On. Under feeding-timer

display mode a solid BELL icon means the feeding time has already passed. A

ashing BELL icon means the feeding time has not been reached. This lets the

user know how many feedings are left for feeding.

6. If the time for the next feeding is set earlier than the present feeding time, the

feeding will start the next day.

7. If the Mode key is pressed and held for more than 2 seconds the number will ra-

pidly increase automatically until you release the key. When number reaches its

maximum, the number will fall back to the minimum value and start increasing

againt.

8. If the feeding timer has already begun, pressing the START key will reset the

timer and begin again from the 1st feeding-time set.

9. If START TOMORROW key is pressed, both the BELL and Zz icon will be ON. The

Zz icon will turn OFF at 0:00 midnight to indicate the timer has started.

10. START TOMORROW is used should you want to set your feeder up today and

have it start tomorrow. This is good for when you have programmed feeding

times that have yet to pass so you can prepare in advance for a possible trip or

just being away the next day and not wanting the feeder to run the day you

programmed it

KEEP ALL SAFETY INSTRUCTIONS AND INSTRUCTIONS FOR

THE FUTURE! ACCIDENT HAZARD AND DANGER TO LIFE FOR

TODDLERS AND YOUNG CHILDREN!

Never leave children unsupervised with the packaging material. There is a risk of

suocation. Keep children away from the product.

DANGER TO LIFE!

Batteries do not belong into children‘s hands. Don’t leave batteries freely accessible.

There is a risk that they may be swallowed by children or pets. If swallowed, seek

medical advice immediately.

This device may be used by children over 8 years of age as well as by persons with

reduced physical, sensory or mental abilities or lack of experience and knowledge

when they are supervised or instructed regarding the safe use of the device and when

they understand the resulting dangers of using the device.

Children must not play with the appliance. Cleaning and maintenance must not be

performed by children without supervision. Do not use the product if you notice any

damage.

FIRE HAZARD!

The batteries must not be short-circuited. Overheating, re or bursting can result from

this.

EXPLOSION HAZARD!

Never throw batteries into re or water. Do not recharge batteries that are not rechar-

geable! The batteries can explode. Leaked or damaged batteries can cause chemical

burns when in contact with the skin; be sure to wear suitable protective gloves in this

case. Remove used batteries from the device. Very old or used batteries can leak. The

chemical liquid will damage the product.

Remove the batteries from the device when not in use for an extended period of

time. Always use batteries of the same type (see chapter „Technical data“). Check the

batteries regularly for signs of leakage. Do not expose the product to high tempera-

tures or humidity as this could damage the product. Prevent mechanical stress on the

product! In the event of damage, repairs or other problems with the light wire, consult

an electrician. Do not mix old and new batteries.

Disposal

The packaging consists of environmentally friendly materials, which can be disposed

of at the local recycling centers.

You can nd out how to dispose of the disused product at your municipal adminis-

tration. Throw your product when it has depleted, in the interest of environmental

protection not in the household waste, but lead it to a proper disposal. You can get

information about collection points and their opening hours at your local administra-

tion.

Do not throw electrical appliances into household waste! According to the

European Directive 2012/19/EC on electrical waste and electronic equip-

ment and its implementation in national law, disused electrical equip

ment must be collected separately and recycled in an environmentally

sound manner. Therefore, electrical appliances are marked with the pictured symbol.

Defective or used batteries must be recycled in accordance with

Directive 2006/66/EC. Return batteries and / or the device to the

collection points provided. Batteries must not be disposed of via

household waste. They may contain toxic heavy metals and are subject

to special waste treatment.

Declaration of Conformity

The EU Declaration of Conformity is available under the contact data for the query and

can be requested if required.

Date of information: 2017

Art. Nr. 50132

dobar Trading GmbH & Co. KG

Fabrikstr. 3 ∙ D - 48599 Gronau

+49 (0)25 62 / 81 46 27

service@dobar-e.com

Dobar 50132 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info