Bedienungsanleitung Eden HA700 (Seite 22 von 23) (Englisch)

547014

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

button has been pressed.

Under normal battery conditions the LED will

extinguish when the button is released.

Motion Sensors

Under low battery conditions the LED behind the

sensor lens will flash when movement is detected to

indicate that the battery needs to be replaced.

Under normal battery conditions the LED does not

illuminate unless the Motion Sensor is in Walk Test

mode.

Door/Window Contact Detectors

Under low battery conditions, when the Detector is

activated the transmit LED will be illuminated for

approximately 1s as the door/window is opened.

Under normal battery conditions the LED will not

illuminate as the Detector is operated, (unless the

Detector is in Test Mode with the tamper switch not

being pressed).

MAINTENANCE

Your Alarm System requires very little maintenance.

However, a few simple tasks will ensure its continued

reliability and operation.

CONTROL PANEL

The new batteries have a typical life of 2 years and

need no maintenance during this period. The

batteries will be damaged if they are not in use for long

periods.

DETECTORS AND REMOTE

CONTROLLER

The Detectors require very little maintenance. The

batteries should be replaced once a year or when a low

battery status is indicated.

IMPORTANT: Should you, for any reason, have to

completely power-down the system (e.g. to move the

system to a new premises) first put the system into Test

mode before removing the Control Panel from the

mounting bracket and disconnecting the power supply.

BATTERIES

Before removing the battery cover on any device to

replace the battery, ensure that the system is put into

Test mode to avoid initiating an Alarm.

The specifications for replacement batteries are as

follows:

Remote

Controllers

1 x 3V CR2032 Lithium Cells

(or equivalent)

Door/Window

Contact

Detectors

3 x 1.5V AAA Size alkaline

battery (or equivalent)

Motion Sensors 3 x 1.5V AA Size alkaline

battery (or equivalent)

At the end of their useful life the batteries should be

disposed of via a suitable Recycling Centre. Do not

dispose of with your normal household waste. DO

NOT BURN.

TROUBLESHOOTING

Forgot password

1. Remove Control Panel from the wall, set

Control Panel in test mode as prerequisite.

2. Remove all power sources from the Control

Panel, such as batteries and DC jack.

3. Move the pin of jumper link to reset position and

reconnect batteries or DC jack.

4. After refitting batteries, the Green statut LED

will turn on for three second indicating the

Control Panel is powered up. When LED turns

off, it implies initial power up is successful. Start

operating the Control Panel.

5. The default password is 1234.

6. Move the pin of jumper link to its original

position.

All of settings will be reset including password,

telephone number and ID codes.

Control Panel not reacting to remote controller

or keypad

Restart learning ID code.

Control Panel not reacting to Motion Sensor(s)

and Door/Window Contact Detector(s)

Restart learning ID code.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eden HA700 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eden HA700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info