48286
73
Zoom out
Zoom in
Vorherige Seite
1/368
Nächste Seite
MYRICA VQ32-1 / MYRICA VQ40-2
Important notes
Here you will find essential safety information that you must be aware of when using your TV set.
!
Do not allow still images to be displayed for an extended time, e.g. still images from
videos, station label etc. (maximum of 1 hour). These pictures may remain visible! Also, do
not allow prolonged operation in a picture mode in which black bars are visible (i.e.
operation in 4:3 picture aspect). These black bars can also remain visible.
i
This product from Fujitsu Siemens Computers contains intellectual property of third
parties. Any tampering with or modification of the product will void the warranty and may
lead to legal prosecution to the full extent of the law.
i
In this manual "PC" is used to identify sets with the "VGA" PC video interface.
Safety information
i
This device complies with all relevant safety regulations for audio, video and TV
equipment.
If you have any questions, contact your sales outlet or our help desk.
The TV set's flat panel is sensitive to pressure and scratches. You should therefore be careful
with the flat panel so as to avoid lasting damage (Newton rings, scratches).
If the device is brought into the installation site from a cold environment, condensation can
form. Before operating the device, wait until it is absolutely dry and has reached approximately
the same temperature as the installation site.
During installation and before operating the device, observe the instructions on environmental
conditions in the Preparations chapter.
To ensure sufficient ventilation, the air inlet and outlet openings of the device must be kept
clear.
The MYRIVA VQ40-2 automatically sets itself to the correct voltage within the range from 110
V to 240 V. The MYRICA VQ32-1 is designed for 240 V. Make sure that the local mains voltage
is not more or less than this range.
The device must only be connected to an earthed mains outlet.
Ensure that the power socket on the device or the earthed mains outlet is easily accessible.
The ON/OFF switch does not fully disconnect the TV from the mains voltage. To disconnect
fully from the mains supply, remove the power plug from the socket.
Lay the cables in such a way that they do not create a hazard (danger of tripping) and cannot
be damaged. When connecting the set, observe the relevant notes in the chapter
"
Preparation".
No antenna or data transfer cables should be connected or disconnected during a
thunderstorm.
Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get inside the
device (danger of electric shock, short circuit).
A26361-K1139-Z120-1-M119, Edition 1 English - 3
73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

fujitsu-siemens-myrica-vq40-2

Suche zurücksetzen

  • Beim umstellen meines Fernseher habe ich alle kabel entfernt.. Beim neu verkabeln ist jetzt ein Fehler. Er erkennt mein Receiver nicht mehr.. Da steht Reset HDCP.. was kann ich tun ? Reset ?. Wie geht das bei meinem Fernseher Eingereicht am 13-11-2018 15:57

    Antworten Frage melden
  • Hallo.
    Ich suche Netzteil für meine Myrica LCD-TV VQ 40-2 TB
    kan jemand mir helfen vo das ich kaufe.

    mfg Eingereicht am 19-11-2013 15:20

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fujitsu Siemens MYRICA VQ40-2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info