Bedienungsanleitung Futaba FP5NLH (Seite 3 von 6) (Englisch)

30012

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Nonslip adjustable lever head

The length of the lever head can be adjusted to fit the operator.

Transmitter NiCad battery NT-8LP

Adjust to the length of your hand

Lever head

in the arrow direction, and adjust the head to

the most comfortable length, then lock it by

turning it in the direction opposite the arrows.

Fig.

Neutral

elevator.

Idle up trimmer

This trimmer is effective

The idle up amount of

the throttle servo can

be adjusted and set

within this range with

FJ9. 6 the throttle up trimmer.

when the idle up switch

is ON. It adjusts and sets the

throttle hold maximum slow

position, and can be set as

shown in the figure.

Trimmer

is for the ailer-

on and trimmer

for the

Transmitter crystal

Aileron AST trimmer

Elevator AST trimmer

AST is the abbreviation of

Adjustable Servo Throw. The

servo throw can be adjusted

and set as shown in the fig-

ure.

Throw can be

adjusted and

set over this

range. 40% —

100%

Fig.

MAXIMUM

SLOW

Servo reversing switches

Using the servo reversing switches

• The left side of each switch is the normal position.

• The servo reversing switches reverse the direction of operation of the

servos.

Elevator servo Throttle servo

reversing switch reversing switch

After linkage is complete, inspect the servos. If the direction of

operation of the stick lever and the direction of operation of a

servo are opposite, switch the appropriate servo reversing switch.

Battery cover

Remove this cover

when switching the

servo reversing

switches.

Remove the

battery

cover, by

pulling it in

the arrow

direction while

pressing

downward.

Fig.

NORM-> Normal

REV -> Reverse

Pitch

control

servo

reversing

switch

Rudder servo

reversing switch

Aileron servo

reversing switch

The tension of the stick lever spring can be adjusted.

Fig.

Charging jack

Battery charge jack for built-in NiCad battery.

•CHARGING OF

TRANSMITTER

AND RECEIVER

NI-CAD BATTERIES:

Battery Charger

Type FBC-8B(4)

Recharge the receiver and

transmitter NiCad batteries

as shown in Fig. 10.

Notes:

1) First, connect to TX NiCad

and red lamp goes on.

2) Then connect to RX NiCad

after connecting, L, E, D,

chanqes color from red to

• Connect the charging plug of the FBC-8B charge to the transmitter

charging jack, connect the 3P connector of the FBC-8B to the re-

ceiver NiCad battery (NR-4J), and plug the FBC-8B to a 117VAC

outlet as shown in this figure.

• The Receiver battery can be used about 10 times at 10 minutes per

flight between rechargings.

• Charge the batteries for about 15 hours. When the set is not in use for

some time, repeat discharge and charge two to three times before use.

(If the batteries are not used for a long time, their capacity will go

down).

• FBC-8B charges transmitter and receiver NiCad batteries independent-

ly or simultaneously.

Lever head

. by turning them

Unlock lever heads

and

Throttle stick deflection

HIGH

Pig.

(NR-4J)

greenish red (orange)

which indicates that

both TX and RX NiCads

are being charged.

3) In case of separate

charging

L, E, D, color will be:

RX NiCad - Green.

TX NiCad - Red.

Charging

plug

LED

Rx:

When adjusting the

aileron, and elevator

the inside module

is removed.

Use a small Phillips

screwdriver.

Elevator

Aileron

Rudder

When these screws are

removed, the back cover

can be removed.

• The tension of the

spring can be adjusted

by removing the trans-

mitter back cover and

turning the screw for

each stick. Set the

springs for the best

stick feel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba FP5NLH Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info