762359
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
3 4
Improving Sound by Switching Channels
The CL7350 can transmit on either of two built-in
frequency channels. You can select the channel that
will produce better audio quality.
1. If the audio sound is distorted or unclear, press the
Auto Tune Button on the TV Receiver (see figure (7)),
to match the frequency of Channel 1 or Channel 2
set at the back of Transmitter. Allow a few seconds
for the audio to resume.
2. If this does not help, switch the channel selector on
the rear of the Charging Cradle (see figure (8)) and
see if the audio quality has improved.
3. Press the Auto Tune button again to improve the
quality still further.
NOTE: The Transmitter will turn off automatically after
about 5 minutes if there is no audio signal from the
audio source (TV set, etc.), or the signal from the
audio source is too weak for proper reception.
However, if the audio signal returns to an acceptable
level, the transmission will automatically restart.
Controlling the Tone (Bass & Treble)
You can adjust the tone of the audio you are listening to and enhance your listening
pleasure by amplifying either the
Treble or the Bass in the Headset
Receiver.
Press the Tone Clarity Button
to switch cyclically between :
1.Enhanced treble (yellow LED glows
),
2.Enhanced bass (blue LED glows
), or
3.Flat tone (bass and treble equally
enhanced, no LEDs glowing ).
Adjusting the Sound Balance (left-right)
You can adjust the sound to suit your hearing in each ear.
With the Receiver on, rotate the Sound Balance button (see
figure (10)) to adjust the sound – you will notice that the sound
seems to “drift” from one side to the other. Play with this
button until you find your most pleasant sound balance.
Using the Mic Button and Microphone for
Conversation
You can switch from Listening mode to Conversation mode
without having to take off the Receiver.
To talk or listen to someone:
1. Press the Mic button (see figure (11)). This will shut off the
Audio Source and the Receiver will become an amplifier
by activating the Microphone.
2. To resume listening to your audio device, press the Mic
button again. The microphone will be shut off and the
audio will resume.
Charging the Battery
1. The signal LED Indicator on the Headset Receiver will
blink slowly when the battery level is low. At this stage
there are about 20 minutes of operating time before the
Headset will switch off. Recharge the battery.
2. Switch OFF the On/Off Switch on the Headset (see figure
(12)). The green LED on the Headset should turn off.
3. Place the Headphone on the Charging Cradle (see figure
(13)), make sure the charge contact touches the charge
pins on the Charging Cradle.
4. The Charging process starts automatically.
• The LED Indicator glows red during charging.
• It will glow in green after the battery is fully charged.
WARNING:
The battery must not be exposed to excessive heat such
as sunshine, fire etc.
Do not attempt to replace the original rechargeable
battery.
When the headphones are not in use, move the switch
to the OFF position to avoid damaging the batteries.
The battery must always be fully charged before first use. An initial 3 hours charge is
required to guarantee an acceptable service life for the rechargeable battery. Always
ensure that the Receiver is switched to OFF position while the battery is charging.
Excessive sound pressure from earphones and headphones can cause hearing loss.
IMPORTANT:
This unit should be operated with built-in rechargeable battery only. When replacing
the battery or when disposing of the unit, always comply with applicable laws relating
to the disposal of battery. Please place them in a proper disposal container to ensure
that they are eliminated safely and in an environmentally friendly way.
TECHNICAL SPECIFICATIONS
Battery operating Time : Up to 6 Hours
Range : Up to 25 meters (open area)
Frequency response : 30 Hz – 10K Hz
Signal-to-noise ratio : >65 dB
Distortion : <2%
Headset weight : 50 grams
Operating voltage : Charging Cradle: 8V, 400mA
: Headset: 3.7V, 350mA Lithium Polymer Battery
Transmission mode : UHF Stereo
Carrier frequency : 863 MHz (CL7350 OPTI VDE&UK version)
: 900 MHz (CL7350 OPTI US version)
TROUBLESHOOTING
No Sound
Ensure the power supply is properly plugged into the electricity socket and that its
cable is properly connected to the DC IN connector on the Charge Cradle.
Ensure that the Headset Power ON/OFF switch is switched ON.
Check the state of the Battery charging in the Headset – place it in the Charge
Cradle and recharge the battery until the Battery Charge LED turns green.
Ensure that the TV set, Hi-Fi system or audio component is switched ON and set
to a channel that broadcasts an audio signal.
Ensure that the volume on the connected audio component is turned up to at least
half its full volume.
The connected audio/video equipment may not be in playback mode. Start
playback on by the equipment.
Use the Volume Control on the Headset to turn up the volume.
Check whether the Headset volume level is set too low. Adjust the volume to a
suitable level.
If the sound is not clear and distorted, change the frequency Channel selection on
the back of the Charge Cradle, and then press the Auto Tune Button on the
Headset Receiver for better reception.
Distortion
The battery inside Headset may need charging. Recharge the battery.
The Headset may be too far away from the transmitter inside the Charge Cradle.
Bring them closer together.
The audio signal input level from the audio source is too low. Increase the volume
at the audio source.
If the sound is not clear and distorted, change the frequency Channel on the back
of the Charge Cradle, and then press the Auto Tune Button on the Headset for
better reception.
.
Cleaning & Maintenance
Note: DO NOT use alcohol, chemical or spirit based cleaning agents.
Wipe Base and Headset clean with a damp cloth.
GUARANTEE
From the moment your Geemarc product is purchased, Geemarc guarantee it for
the period of two years. During this time, all repairs or replacements (at our
discretion) are free of charge. Should you experience a problem then contact our
help line or visit our website at www.geemarc.com.
The guarantee does not cover accidents, negligence or breakages to any parts. The
product must not be tampered with or taken apart by anyone who is not an
authorized Geemarc representative.
The Geemarc guarantee in no way limits your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE AND MUST BE
RETAINED AND PRODUCED IN THE EVENT OF A WARRANTY CLAIM.
Please note: The guarantee applies to the United Kingdom only.
DECLARATIONS
CE Directives
Geemarc Telecom SA hereby declares that this product is in compliance
with the essential requirements and other relevant provisions of the Radio and
Telecommunications Terminal Equipment Directive 2014/53/UE.
The CE declaration of conformity may be consulted at www.geemarc.com
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
FCC CAUTION
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment. This device and
its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Electrical connection: The apparatus is designed to operate from a 230V 50Hz
supply only. (Classified as hazardous voltage according to EN60950 standard). The
apparatus does not incorporate an integral power on/off switch. To switch off the
apparatus, disconnect the power adaptor.
When installing the apparatus, ensure that the mains power socket is readily accessible.
Recycling Directives
The WEEE (Waste Electrical and Electronic Equipment) has been put in
place for the products at the end of their useful life are recycled in the best way.
When this product is finished with, please do not put it in your domestic waste bin.
Please use one of the following disposal options:
- Remove the batteries and deposit them in an appropriate WEEE skip.
Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a new one, they should
accept it.
Thus if you respect these instructions you ensure human health and environmental
protection.
For product support and help visit our website at www.geemarc.com
Contact Geemarc UK:
5B Swallow Court, Swallowfields, Welwyn Garden City, Hertfordshire, AL7 1SB,UK
telephone 01707 387602
or fax 01707 832529
QUGCL7350 OPTI_En_A3_V1.2
Mute
Button
Microphone
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Geemarc CL7350 Opti wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Geemarc CL7350 Opti

Geemarc CL7350 Opti Kurzanleitung - Deutsch - 2 seiten

Geemarc CL7350 Opti Kurzanleitung - Holländisch - 2 seiten

Geemarc CL7350 Opti Kurzanleitung - Französisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info