Bedienungsanleitung Gemini 7563 (Seite 4 von 8) (Englisch)

479858

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

PAG. 6

PAG. 7

Being closed all the doors of the vehicle, turn the ignition key to “ON”; after 20”,

all doors will be locked.

By turning the ignition key to “OFF”, all doors of the vehicle will be automatically

unlocked.

After programming, this function is obtained simply by turning the ignition key

to “OFF”.

When opening a vehicle's door during passive arming, the arming time count

will be set to zero and the led will be permanently illuminated; when the door is

closed the 45” counting will restart.

LOCKING TIME

The standard locking time of the alarm is set to 0,5”.

In case the vehicle needs a locking time of 6”, you can vary this parameter

during the programming phase.

NOTE: When the comfort function has been activated, let the locking time set

to 0,5”.

In fact, if the locking time is set to 6”, when the alarm is disarmed, the windows

of the vehicle will open.

COMFORT CONTROL

The comfort control allows the automatic regulation of window closing, when

the alarm is armed.

In fact, after this function has been activated, at any alarm arming, the window

winder motor/control unit will receive a 25” command, to close the windows.

To prevent this function from being activated accidentally, the system

continuously monitors the status of the ignition key and the input line of the

DOOR AND BOOT PUSHBUTTONS and therefore does not allow operation of

the locks if the DOORS and BOOT are opened manually while starting the

engine or during the 20” after starting it.

PASSIVE ARMING

Automatic arming allows to have the alarm system active, 45 seconds after the

engine switching “OFF”.

The alarm will indicate the passive arming activation by a long flash of the turn

signals, two flash of the status led and two acoustic signals.

CDL DOUBLE OPENING PULSE

By enabling this function you will obtain, upon deactivation of the system, a

double control pulse on the door-unlocking line (about 0,5 second each).

This allows the opening of the centralized door locks on vehicles having the

diversified door opening (first pulse driver side door opening, second pulse

other doors opening).

This function is active only if the opening/closing time of 0,5” is selected, while

setting the opening/closing timo of 6” will automatically disabled the double

pulse.

PROGRAMMING THE ALARM SYSTEM

Has been previously programmed with standard configuration during

manufacturing procedure by Gemini, and can be modified in any moment

! With alarm being disarmed, open and keep it open the driver side door.

! Turn the ignition key to "ON" position.

! The status led stay on for 0,5 seconds; during this time, push together the

two buttons of the remote control.

! Starting of programming procedure is indicated by two acoustic signals,

one with high tone and one with loud tones, furthermore the led is

permanently illuminated.

! To able and disable the functions, follow the below table, take into

consideration that every time the push button of transmitter is pressed, the

system goes to the following function.

During the programming phases, press the radio control (rough) push-button

n.1, for function activation and the (smooth) push-button n.2, for function de-

activation.

ATTENTION: pay attention to not modify the functions which have been

programmed during the installation.

For the programming modification proceed as follows:

NOTE:

Once the last function has been programmed, the alarm will confirm that

the programming has been disabled with two acoustic signals with low

tone, one acoustic signal with high tone,

! Turn the ignition key to “OFF” position.

by turning the ignition key to “

OFF”, in any moment of the programming

procedure, the latter will stop and successive functions will remain unchanged.

furthermore the led will be turned

off.

Acoustic signals

Panic alarm or “car finder”

Passive arming

Current absorption sensor

Anti-distraction, automatic

door locking function

Setting of centralized lock

times (0,5 - 6 sec)

25 seconds comfort closure

command

Double impulse in opening

Enabled

Enabled panic

alarm

Disabled

0,5” selected

Disabled

Button N°1- Enable

N°2- Disable

N°1- Enable panic

N°2- Enable

N°1-

N°2-

N°1-

N°2-

Button

Button car-finder

Button Enable

Button Disable

Button N°1- Enable

Button N°2- Disable

Button Enable

Button Disable

Button N°1- Enable 6”

Button N°2- Enable 0,5”

Button N°1- Enable

Button N°2- Disable

Button N°1- Abilita

Button N°2- Disable

FUNCTION

STATE BUTTON

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gemini 7563 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info