Bedienungsanleitung Gemini 932 (Seite 3 von 9) (Englisch)

479886

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

2.5 - SYSTEM ARMED

2.6 - ALARM, INHIBIT TIME BETWEEN ALARMS AND ALARM CYCLES

2.7 - SYSTEM DISARMING

2.8 - EMERGENCY DISARMING BY ELECTRONIC KEY

After the inhibit time the system is “armed” and ready to detect any theft attempt.

When the system is fully armed, the LED flashes.

Atheft attempt indicated

before another alarm cycle starts,

Press the unlock button on the vehicle original remote control.

Disarming is confirmed by two siren chirp and two flashes of the turn

indicators.

(2.9) signals.

This disarming

is by acoustic/optical signals.

After the alarm is triggered, but the system goes into “neutral time”

for about 5“.

An alarm event can generate up to alarm cycles of 30” each for each input and for each arming

cycle

(if feature has been modified)

An alarm condition is signalled by five acoustic signals (if feature has been modified) and five flashes

of the turn indicators.

Relative paragraph lists the various alarm causes and relative LED

mode is used for “EMERGENCY DISARMING” and “TOTAL DISARMING”.

Touching the electronic key to its receptable disarms and switches off the system which does not

rearm when the remote control is used.

To restore normal operation, touch the electronic key to its receptacle.

A quick chirp and a flash of the status LED confirm that the system is back to normal

mode.

2.9 - ALARM MEMORY

chirp of the siren ( )Five flashes of the turn indicators and five if feature has been modified upon

disarming indicate a theft attempt.

The last cause of alarm can be identified by the LED memory.

Turn ignition key “ON” ; the vehicle status LED blinks according to the last alarm detected.

Optical signals are repeated 3 times; to interrupt, turn ignition key “OFF”.

The table below lists the various alarm causes and relative LED signals.

PAGE 04 - USER MANUAL USER MANUAL - PAGE 05

3.0 - WARRANTY CONDITIONS

This product is guaranteed to be free from manufacturing defects for a period of 24 months from the

installation date shown on this warranty, in compliance with the Directive 1999/44/CE.

Please fill-in entirely the guarantee certificate included in this booklet and do NOT REMOVE the

guarantee label from the device.

The warranty will become void if labels are missing or torn, if the installation certificate is not fully

compiled or if the enclosed sale document is missing.

The guarantee is valid exclusively at authorized Gemini Technologies S.p.A. Service Centers.

The manufacturer declines any responsibility for eventual malfunctions of the device or any damage

to the vehicle electrical system due to improper installation, use or tampering.

This alarm system is solely intended to be a theft-deterrent device.

4.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

(WEEE) DIRECTIVE

The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and

Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.

LED FLASHES ALARM CAUSES

Nr. OF

ALARM

Ignition attempt (+15/54)

Door opening

Bonnet opening

Volumetric or external sensor

Wire tampering

Boot opening

LED ON (1 second)LED OFF (2 seconds)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gemini 932 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gemini 932

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info