Bedienungsanleitung Gorenje b 9010 al (Seite 14 von 17) (Englisch)

330554

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Instructions for use, installation and connection

Removing oven door

(differ according to different models)

Open the door to the horizontal position. Pull the bottom hinge

supports upwards to the vertical position and lock them to the

latch of upper hinge support. Close the door halfway (see fig.)

and pull it out.

For reinserting the door repeat the procedure backwards. Insert

the door in half open position (at an angle of 60°) by pushing

them all the way in during opening. Be sure that the notches on

bottom hinge carriers fit exactly the oven floor. Now open the

door completely, remove the hinge clamps from the upper

hinge latches and return them into the horizontal position.

1 door hinge in 2 door hinge during

operating position dismantling

Removing oven door with a single axe hinge

(differ according to different models)

Open the door completely and turn the removable locks

backwards (see fig). Then close the door slowly and let the

locks fit to the notches. At an angle of about 15° lift the door

slightly up and pull the door from the hinge supports (fig. 2).

For reinserting the door repeat the procedure backwards. Insert

the door at an angle of about 15° into the hinge supports by

pushing them forward and downwards, so the hinges lock into

their slots (fig. 3). Check if the hinges are locked into their

respective slots.

Now open the door completely and turn the removable locks

into their original position. Close the door slowly and check if

they close properly (fig. 4). If you have trouble closing the door,

check if the hinges are properly inserted into their slots.

Attention! Never let the hinge locks spring out, as the springs

are strong and may cause injuries.

Accessories

Accessories, like biscuit tray, oven grid, etc. are cleaned with

hot water and the usual detergent.

Special enamel

Oven, interior door lining, baking tray and grease interception

pan are coated with special enamel, with smooth and resistant

surface.

This special coating facilitates cleaning at room temperature.

Grease filter

Clean the grease filter after each use with soft brush in hot

water with some detergent, or wash it in the dishwasher.

Troubleshooting guide

Any unskilled attempt to repair the appliance is extremely

dangerous as it might cause electric shock and short circuit. To

avoid such injuries any repairs may be performed only by

qualified personnel, or after sales service.

However, there are some minor faults which may be easily

removed by the user, in accordance with the instructions that

follow.

Important!

If the malfunction of the appliance was caused by the improper

use, the service visit during the warranty period is not free of

charge.

Following are some simple advice how to repair minor faults:

Program clock indicates faulty values or switches on and

off intermitently…

Switch the cooker off, disconnect it from the mains for a few

minutes (unlock the fuse or switch off the main switch), then

reconnect it to the mains and set the correct daily time.

Program clock display is flashing…

There was a power failure, or the cooker had been connected

to the mains for the first time. All settings are erased. Set the

correct time of day to be able to activate the oven. After

operating in automatic mode, the oven switches off, the display

indicates time, and the beep is heard. Take the food from the

oven, set the temperature selection knob and the mode knob

into their original positions. Select the "Manual mode", and use

the oven in a conventional mode (without programming).

Signal lamp does not turn on....

• are all the required switches properly activated?

• is the mains power fuse burned?

• is the temperature regulator properly set?

Fuses often burn out...

• Call the serviceman or your electrician!

Oven illumination is not on....

• Exchange of oven bulb is described in the section

"Replacement of parts".

Oven does not heat up...

• is the mains power fuse burned?

• is the temperature regulator set correctly?

• did you set the oven to the conventional mode after using it

in the automatic mode (programmed)? Switch the mode

button to the position "Manual mode".

Baking results are disappointing...

• did you remove the grease filter?

• did you follow the instructions and warnings from the section

"Baking"?

• did you strictly follow the information from the baking table?

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje b 9010 al Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info