Bedienungsanleitung Gorenje ect 680 al (Seite 3 von 18) (Englisch)

335437

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Instructions for use, mounting and connection

Basic adjustment of sensors to the

ambience

Upon each connection to the power supply the

sensors of the appliance are automatically adjusted to

the environment to ensure their proper function. All

displays indicate the sign "-".

Once the successful adjustment is completed it is

signaled with a beep, all displays are switched off and

your cooktop is ready for use.

During the adjustment procedure the sensors must be

free of any objects, otherwise the adjustment

procedure will be interrupted until such objects are

removed from the sensor surface. During this period

the regulation of the cooktop is impossible.

ATTENTION !

Before attempting any repairs on the appliance,

disconnect the power supply. In accordance with the

mains voltage the appliance should be connected in

line with the attached diagram. The earthing wire (PE)

must be connected to the terminal marked with the

earthing symbol

The connection cable must lead through the relief

safety device, protecting it from accidental pulling out.

Upon the completion of installation switch all the

hotplates on for about 3 minutes to check the proper

functioning.

Installation diagram

NOTE

In some connection boxes the connector bridges are placed between contacts 4 and 5, and in the others they are

stored at a designated place within the box. These boxes have the connection screws already in open position so

they need not be unscrewed. During the tightening procedure you will hear a faint “click”, meaning that the

tightening screw should be fastened tightly all the way

Connection may be carried out by means of:

− rubber coated connection cables, model H05 RR-F 4x1,5 with yellow-green earthing cable;

− PVC insulated connection cables, model H05 VV-F 4x1,5 with yellow-green earthing cable; or

− any other suitable cables.

Mounting the built-in cooktop

Caution !

• To avoid any possible hazard, the appliance may

be installed by qualified personnel only.

• Panels and furniture lining of the kitchen cabinet

receiving the hob must be treated with

temperature resistant adhesives (100°C),

otherwise they might be discoloured or deformed

because of inadequate temperature resistance.

• The cooking hob is intended for building into the

worktop above the kitchen element of 600 mm

width or more.

• After the installation of built-in hob make sure that

there is free access to the two fixing elements in

front.

• Suspended kitchen elements above the cooktop

must be installed at such distance to provide

enough room for comfortable working process.

• The distance between the worktop and the hood

must be at least such as indicated in the

instructions for installation of the kitchen hood, but

in no case it may be less than 650 mm.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje ect 680 al Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gorenje ect 680 al

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info