Bedienungsanleitung Gorenje ri 2142 la (Seite 6 von 7) (Englisch)

346137

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

Instructions for Use

Cleaning the Appliance

Disconnect the power supply before cleaning the

appliance. Do not use coarse or aggressive cleaning agents

as you can damage the surface. Be careful to remove any

cleanser agent remaining after cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth and an

alcohol based cleaning agent (for example glass cleaners).

You may also use alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially aggressive

cleaners, such as the stainless steel cleaners, is not

appropriate for the cleaning of plastic and coated parts.

• Remove the detachable accesories in the interior of the

appliance and clean it with water and liquid detergent.

Plastic parts cannot be washed in washing machine.

• Wash the interior of the appliance with lukewarm water, in

which you added one or two spoonfuls of vinegar.

• Every now and then wipe the condenser on the rear wall.

Use soft non-metal brush or vacuum cleaner.

• Do not forget to clean also the defrost water receptacle

above the refrigerator compressor (do not remove the

receptacle).

After cleaning, connect the appliance to power supply and

reload the packages.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set

the thermostat knob to the STOP position, disconnect the

power supply, take out the foods and defrost and clean the

appliance. Leave the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

The Appliance Fails to Operate After connecting to the Mains

Supply

• Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat in operating position).

Continuous Operation of the Refrigerating System

• the door was frequently opened or it was left opened for too

long;

• the door is not properly closed (the door may sag, the gasket

may be polluted or damaged);

• perhaps you have overloaded the appliance with fresh foods;

• The reason may be inadequate ventilation of the compressor

and condenser (assure adequate air circulation and wipe off

the condenser);

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the channel and through

the opening to the drain pan on the compressor, automatic

defrosting of the appliance is assured.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP position and leave the door

open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

After completed defrosting, turn the knob to desired position

and close the refrigerator door.

The cause of increased ice formation may be one of the

following:

− the door does not seal well (clean the gasket if it is

contaminated, or replace it if it is damaged);

− the door was frequently opened or it was left opened for too

long;

− the food stored in the refrigerator was warm;

− the food or dish is touching the inner back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged, or the defrost

water drips over the channel, water leaks from the refrigerator.

• Clean the clogged opening, for example with a plastic straw.

• Manually defrost the increased ice layer. See Ice Formation

on the Inner Back Wall.

Noise

Cooling in refrigerating-freezing appliances is enabled by the

refrigerating system with compressor, which produces noise.

How noisy the appliance is depends on where it is placed, how

it is used and how old the appliance is.

• During the operation of the compressor the noise of liquid

is heard and when the compressor is not operating, the

refrigerant flow is heard. This is a normal condition and it

has no influence whatsoever on the lifetime of the appliance.

• After starting the appliance, the operation of the

compressor and the refrigerant flow may be louder, which

does not mean that something is wrong with the appliance

and it has no influence on the lifetime of the appliance.

Gradually the noise is reduced.

• Sometimes unusual and stronger noise is heard, which is

rather unusual for the appliance. This noise is often a

consequence of inadequate placing.

− The appliance shall be placed and levelled firmly on solid

base.

− It should not touch the wall or kitchen units standing next

to it.

− Check the accesories in the interior of the appliance, they

should be placed correctly in their positions; also check

the bottles, tins and other vessels that might touch each

other and rattle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje ri 2142 la Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info