Bedienungsanleitung Grohe Red Duo (Seite 4 von 12) (Englisch)

626604

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Type approvals

The GROHE Red boiling water storage heater

with filter

system must be installed the safety assembly with

expansion

vessel

provided.

The boiling water storage heater

with filter system

may only be

operated together with an original GROHE Red boiling water

fitting.

Application

The GROHE Red boiling water fitting supplies boiling water in

addition to hot and cold tap water. Boiling and mixed water

flows into the GROHE Red fitting through separate pipes and

flows out through two separate areas of the flow straightener.

The GROHE boiling water storage heater is designed to heat

and store drinking water in pressurised systems.

The GROHE boiling water storage heater is suitable for

connection to a mains system with a maximum water pressure

of 0.8 MPa.

It must not be connected to hot water.

The filter system measures the flow rate using a sensor and

from this calculates the remaining capacity of the filter

cartridge as a function of the set litre capacity. If the filter

cartridge litre capacity set on the display unit is exceeded, the

values are displayed as negative values.

The sensor also monitors the maximum service life of the filter

cartridge. If the maximum service life of 12 months is

exceeded, the remaining capacity of the filter cartridge flashes.

The water filtrate is classified as Category 2 according

to EN 1717.

Safety notes

GROHE Red boiling water storage heater:

This device is not intended for use by persons

(including children) with physical, sensory or mental

impairments or a lack of experience or knowledge in

using devices of this type.

Children must be supervised to ensure that they do

not play with the device.

Risk of electric shock. Avoid damaged power supply

cable. In case of damage, the boiling water storage

heater must be replaced by the manufacturer or its

customer service department or an equally qualified

person.

Caution, risk of scalding! Escaping water is boiling

hot. Never touch the end of the spout in order to

swivel the spout as it becomes extremely hot.

•The boiling water storage heater must be connected

to a permanent power supply with earth wire.

• Installation is only possible in frost-free rooms.

• The boiling water storage heater is only suitable for

indoor use.

• The boiling water storage heater must be placed in an

upright position.

• The boiling water storage heater and plug must not be

directly or indirectly sprayed with water when cleaning.

• The boiling water storage heater must not be opened.

• Use only genuine replacement parts and accessories.

The use of other parts will result in voiding of the warranty

and the CE identification, and could lead to injuries.

If the boiling water storage heater is to be drained, the safety

assembly

with

expansion vessel of the boiling water storage

heater must be removed. Invert the boiling water storage

heater and allow the water to run out.

However, we strongly advise against draining the boiling

water storage heater. There is a significant risk of

damaging the boiling water storage heater.

Technical data

Electrical data boiling water storage heater:

• Connection: Wall socket with earth wire, protected

via a 13 A fuse

• Voltage supply: 230 V AC / 50 Hz

• Power consumption: 2100 W

• Standby power loss (switched on): 15 W

• Standby power loss (switched off): 1 W

• Type of protection: IPX4

Filter system:

• Sensor battery: 3 V lithium battery (type CR 2032)

• Cable length: 1,500mm

• Display unit rating (wall installation): IPX4

• Sensor rating: IPX8

Sanitary data boiling water storage heater, fitting:

• Boiling water storage heater capacity: 4 l

• Flow pressure:

– min. 0.1 MPa

– recommended 0.1 – 0.5 MPa

• Operating pressure: max. 0.2 – 0.8 MPa

• Test pressure: 1.6 MPa

• Flow rate at 0.3 MPa flow pressure

- Mixed water: approx. 6.8 l/min

- Boiling water: approx. 3.4 l/min

• Boiling water temperature 99 °C

The actual temperature may differ slightly due to different

ambient pressures

• Heating time from 10 °C to 99 °C: approx. 15 min

• Available storage heater volume at 99 °C: 3 l/min

• Max. chlorine value: 100 mg/l

• Water connection at storage heater: Cold water

• Water connection at fitting: Cold water from service valve

Hot water from service valve

Boiling water from storage heater

New Water Regulations

Please ensure installation complies with New Water Regula-

tions. It must also be installed in accordance with local bye-law

requirements.

Approval and conformity

The conformity declarations can be obtained from the following

address:

GROHE Deutschland Vertriebs GmbH

Zur Porta 9

D-32457 Porta Westfalica

This product conforms to the requirements of the

relevant EU guidelines.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grohe Red Duo Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Grohe Red Duo

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info