564761
5
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
5
How do I heat correctly ?
heating
small wood logs on top
lighting aid in between
some wood logs at the bottom
5.5. Adding fuel
Apart from using suitable fuel and sufficient chimney draft,
the stove operation has a major effect on keeping the view
window clean. In this context we recommend charging fuel
in only one layer, preferably using large (approx. 33 cm),
wood billets largely filling the firebox width. Briquettes
should be arranged in the firebox so that they cover the
surface as far as possible (approx. 5 to 10 mm spacing
between the briquettes).
Note! Additional fuel should only be placed on the basic
embers (no flame remaining).
Before opening the firebox door you should fully close all
air dampers (see Equipment Sheet) to prevent flue gases
from the combustion chamber leaking into the living room.
Once the fuel has been charged, close the firebox door again.
Following this, fully open all air dampers immediately to
keep the time span to the lighting of the fuel as short as
possible. As soon as the fuel is burning lively, restore the
damper position gradually as shown on the enclosed
Equipment Sheet
5.6. Operating mode during the transition period
During the seasonal transition period or in the event of
higher outside temperatures it is possible that chimney draft
problems occur under certain conditions during a sudden
increase in temperature, so that the exhaust gases are not
fully extracted. For this reason the stove should only be
operated with the least amount of fuel in the seasonal
transition period so that improvement of the combustion and
the draft situation is possible by opening the air damper in
such cases.
5.7. De-ashing
After extended combustion, at least once per day, discharge
the ash through the grate into the ash pan using a hooked
poker and empty the ash pan. This is best done in the
morning after embers heating overnight with the stove in a
relatively cold state. Please ensure that the ash pan is
emptied when approximately half full so that the ash cone
does not grow up too closely to the grate. If the grate is
packed into the ash cone there is a risk for it to get damaged
through overheating since no cooling air can get to it.
Caution:
Prior to de-ashing always check if no residual embers are
present in the ash. Even if the ash is cold it may still contain
traces of embers that could lead to a fire in the waste bin.
Wood ash can be used as fertiliser.
5.8. Emission limitation
The wood stove has been built for the combustion of low-
smoke fuels.
According to the Federal Emission Protection Act the
following must not be combusted for instance:
Moist wood or wood treated with wood protection
agent,
Fine wood chips,
Paper and cardboard (except for lighting),
Barks or chipboard waste,
Plastic or other waste.
Burning such materials will not only harm the environment
but also shorten the service life of your wood stove and the
chimney may also be damaged. Regular cleaning and care of
your stove also reduces pollutant emission. Obviously bark
adhering to wood billets can be burnt.
5.9. Cleaning and care
At least once per year, if required more frequently, clean and
service your wood stove n the cold condition. To do so,
remove the ash deposits in the flue pipe and the smoke baffle
plates or draft baffle plates. Draft baffle plates made of
ceramic fibre or vermiculite can be removed for cleaning
(see Equipment Sheet). Please reinstall carefully in the same
position after cleaning. For cleaning the flue gas drafts an
ash extractor with fine particle filter is highly suitable. Dirt
on the view windowpane is best and most environmentally
friendly removed using a scouring pad moistened with water
and dipped into wood ash or other commercially available
domestic glass cleaners.
The chimney must also be regularly cleaned by the chimney
sweep. The required intervals can be enquired from your
responsible master chimney sweep.
The wood stove should be checked annually by a specialist.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Haas-Sohn FUEGO wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Haas-Sohn FUEGO

Haas-Sohn FUEGO Bedienungsanleitung - Deutsch - 6 seiten

Haas-Sohn FUEGO Bedienungsanleitung - Deutsch - 6 seiten

Haas-Sohn FUEGO Bedienungsanleitung - Französisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info