Bedienungsanleitung Harman Kardon AVR85 (Seite 37 von 40) (Englisch)

502655

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Memory Backup

This product is equipped with a memory

backup system that preserves tuner pre-

sets and system configuration informa-

tion if the unit is accidentally unplugged

or subject to a power outage. This mem-

ory will last for approximately one week,

after which time all information must be

re-entered.

System Reset

In the rare case where the unit’s opera-

tion or the displays seem abnormal, the

cause may involve the erratic operation of

the system’s memory or microprocessor.

To correct this problem, first unplug the

unit from the AC wall outlet and wait at

least three minutes. After the pause,

reconnect the AC power cord and check

the unit’s operation. If the system still

malfunctions, a system reset may clear

the problem.

To clear the entire system memory of the

unit, press and hold the MEMO ^ and

CLEAR & buttons until CLEAR MEMO

appears in the front panel display.

Release the buttons and note that the

unit will turn off and then on.

Remember that once you have cleared

the memory in this fashion it will be

necessary to re-establish all system

configuration information and tuner

presets.

If the system is still operating incorrectly,

there may have been an electrostatic dis-

charge or severe AC line interference that

has corrupted the memory or micro-

processor.

If a reset does not solve the problem,

consult an authorized Harman Kardon

service depot.

Multiroom Operation

Remote Room Control

Operation of the AVR85’s multiroom

system from a remote room location

is very similar to use from the main

room, but it requires prior installation

of an optional remote infrared sensor,

as well as the audio power amplifier and

speakers. An additional optional AVR85

remote control unit or a compatible

remote programmed with the AVR85

codes is also required.

1. Using the remote control, press the

Multi button h to turn the receiver on

and activate the multiroom system.

2. If the multiroom system has been set to

VARIABLE in SET UP MENU 4 you

may change the volume or source using

the appropriate volume buttons

on the remote being used. If the multi-

room volume has been set to FIXED the

volume or source may not be changed.

3. The AVR85’s tuner has been selected

as the multiroom source you may tune

stations or search presets using a

Harman Kardon compatible remote. If

Harman Kardon compatible components

are connected to the AVR85’s rear panel

Remote Control Output jack d the

remote may also be used to control CD

players and cassette decks.

4. To turn the multiroom feed off, press

the Multi button h.

NOTE: The multiroom system may also

be operated from the remote control in

either the main room or the remote

location through the MULTI ROOM

SELECTOR function accessed through

the on-screen menu system. After reach-

ing the MULTI ROOM SEL menu (see

figure #18) use the ‹ or › buttons i

to select a source. This will automatically

turn the multiroom system on, as indi-

cated by the Multi indicator D in the

Information Display.

AVR85 120 rev (g) 6/14/97

AVR85 om (g) 9/16/98 11:21 AM Page 34

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon AVR85 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info