Bedienungsanleitung Honeywell CO8MS (Seite 2 von 49) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

681061

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

Table B – CO alarm response

CO Level (in ppm) Red light Horn / Sounder Red light

0 to 43 off off off

43 to 80

1 ﬂash every

2 second

On within

72 minutes approx.

2 ﬂashes every

50 seconds

80 to 150

1 ﬂash every

second

On within

18 minutes approx.

4 ﬂashes every

50 second

> 150

2 ﬂashes every

second

On within

40 seconds approx.

8 ﬂashes every

50 seconds

2.4 Pre-alarm (red light ﬂashing)

When the alarm detects over 43 ppm CO the red light ﬂashes immediately. The rate that

it ﬂashes will depend on the CO level detected as outlined in Table B. Note the Pre-alarm

signal may be triggered by CO coming for example, from cooking with gas, from car engines

or from nearby barbecues. This is usually not a concern, unless the pre-alarm signal persists

until the alarm sounds and the CO source is unknown.

2.5 Full alarm (horn sounding)

If the CO level persists at a dangerous level the Horn will sound at 85 dB(A). The interval

time between the Pre-alarm and activation of the horn will depend on the concentration of

CO detected as described in Table B.

2.6 CO Alarm memory

The CO Alarm memory is a useful and important feature. If the house is unoccupied it warns

the homeowner if the unit has detected CO gas and been in alarm in their absence. The

memory feature has two operation modes:

24 hour memory: After alarm, the RED light will ﬂash at different rates every 50 seconds

depending on the level of CO detected – see Table B (24 hour Memory Response)

Memory recall on demand: To review the memory status after the 24 hour period press

and hold the test button, the red led will ﬂash at the same rate as if CO was present - See

table B (Alarm response to CO being present)

Reset memory: Hold down the test button for over 12 seconds until the red light stops

ﬂashing. Cover the horn with a cloth to mufﬂe the alarm during this time. Please note that

the memory will also be reset when the unit is switched off.

2.7 What to do when the alarm sounds

1. Open the doors and windows to ventilate the area.

2. Turn off all fuel appliances where possible and stop using them.

3. Evacuate the property leaving the doors and windows open.

4. Get medical help immediately for anyone suffering the effects of carbon monoxide

poisoning (headache, nausea), and advise that carbon monoxide poisoning is

suspected.

5. Call your gas or other fuel supplier on their emergency number. Always keep this

number in a prominent place.

6. Do not re-enter the property until the alarm has stopped. (If the alarm has been

silenced by pressing the test button, wait at least 5 minutes so the alarm can check

that the CO has cleared).

7. Do not use the fuel appliances again until they have been checked by a registered

installer or equivalent expert.

3 Installation

3.1 Where to place CO alarms

This alarm should be installed by a competent person. Ideally a carbon monoxide alarm

should be installed in:

• Every room containing a fuel burning appliance, and

• Remote rooms where occupants spend a considerable amount of time.

• Every bedroom.

However if the number of carbon monoxide alarms to be ﬁtted is limited, the following points

should be considered when deciding where best to ﬁt the alarm(s).

• If there is an appliance in a room where people sleep, place a CO alarm in this room.

• Locate a CO alarm in a room containing a ﬂueless or open-ﬂued appliance.

• Locate an alarm in a room where the occupant(s) spend most of their time. (e.g. sitting

room).

• In a bedsit, the CO alarm should be placed as far away from the cooking appliance as

possible, but near to where the person sleeps.

C08MS

Carbon Monoxide detector –

Installation Instructions

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell CO8MS Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honeywell CO8MS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info