654664
6
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
116
7. While another person holds the Handlebar Post (6)
near the Frame (1), connect the Extension Wire
(18) to the Lower Wire Harness (44).
Next, slide the Handlebar Post (6) onto the Frame
(1). Attach the Handlebar Post with four M8 x 15mm
Button Screws (7) and four M8 Black Flat Washers
(57).
6. Hold the Handlebar (16) near the Handlebar Post (6).
Connect the wire harness to the Extension Wire (18).
Attach the Handlebar (16) to the Handlebar Post (6)
with four M6 x 20mm Button Screws (25) and four
M8 Black Flat Washers (57).
5. Hold the Console Base (9) near the Handlebar (16).
Insert the wire harness through the indicated hole in
the handlebar. Next, connect the two pulse wires to
the two Wires (22) extending from the Handlebar.
Attach the Console Base (9) to the Handlebar (16)
with four Console Screws (20). Be careful to avoid
pinching the wires.
5
9
22
Hole
16
20
16
6
6
7
18
44
57
1
25
57
18
7
6
Pulse
Wires
Wire
Harness
Wire
Harness
Measure your heart rate regularly
During the program, slow your pedaling speed
briefly and measure your heart rate regularly
(refer to step 5 on page 9). Each time you mea-
sure your heart rate, the resistance of the pedals
will automatically increase or decrease, if neces-
sary, to keep your heart rate near the preselect-
ed percentage of your maximum heart rate. It is
not necessary to keep your hands on the metal
contacts when you are not measuring your heart
rate. Note: If your heart rate is not shown,
press the reset button to reset the pulse sen-
sor.
When you are finished exercising, turn off the
power
To turn off the power, simply wait for about
three minutes. If the pedals are not moved and
the console buttons are not pressed for three
minutes, the power will turn off automatically.
65
Inspect and tighten all parts of the exercise cycle reg-
ularly. The exercise cycle can be cleaned with a soft,
damp cloth. To prevent damage to the console, keep
liquids away from the console and keep the console
out of direct sunlight.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. To replace the batteries, the con-
sole must be removed from the console base. Refer
to assembly step 4 on page 5.
PULSE SENSOR TROUBLE-SHOOTING
¥ Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings.
¥ If your heart rate is not shown when the pulse sen-
sor is used, press the resistance Ð button to reset
the pulse sensor.
¥ Do not hold the metal contacts too tightly; doing so
may interfere with heart rate readings.
¥ For the most accurate heart rate reading, hold the
metal contacts for about 15 seconds.
¥ For optimal performance of the pulse sensor, keep
the metal contacts clean. The contacts can be
cleaned with a soft clothÑnever use alcohol,
abrasives, or chemicals.
MAINTENANCE AND TROUBLESHOOTING
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Icon Image 3.2C - IMEX35080 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info