Bedienungsanleitung Indesit XWDE 961480X (Seite 2 von 32) (Englisch, Holländisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

684556

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

WASH CYCLES

Follow the instructions on the symbols of the garment’s wash

care label. The value indicated in the symbol is the maximum

recommended temperature for washing the garment.

Sport: a cycle designed for washing lightly soiled sports clothing

(tracksuits, shorts, etc.); for best results, we recommend not exceeding the

maximum load indicated in the “Wash Cycle Table”. We recommend using liquid

detergent and adding the amount suitable for a half-load.

Dark: use programme 2 to wash dark-coloured garments. This

programme is designed to maintain dark colours over time. We

recommend using a liquid detergent for the best results when washing

dark-coloured garments.

When you select the drying function, at the end of the washing cycle the

machine will automatically perform a delicate drying cycle that preserves the

colours of the garments. The display will show the level “ ”. Max. load: 3 kg.

Anti-odour: use programme 3 for washing garments with bad odours

(e.g. smoke, sweat, fried food). The programme is designed to remove bad

odours while preserving the fabric bres. Synthetics fabrics or mixed

loads should be washed at 40°, and resistant cotton fabrics at 60°.

Delicate: use programme 4 to wash very delicate garments. It is

advisable to turn the garments inside out before washing them. For best

results, use liquid detergent on delicate garments.

When selecting an exclusively time-based drying function, a drying cycle is

performed at the end of the wash cycle that is particularly delicate, thanks

to light handling and appropriate temperature control of the water jet.

The recommended durations are:

1 kg of synthetic garments --> 150 min

1 kg of synthetic and cotton garments --> 180 min

1 kg of cotton garments --> 180 min

The degree of dryness depends on the load and fabric composition.

Wool - Woolmark Apparel Care - Blue:

The “Wool” wash cycle is approved by the Woolmark

Company for washing wool garments classied as

“hand-washable”, provided that the wash complies with

the instructions appearing on the garment’s label and

with those provided by the manufacturer of this washer-

dryer. (M1318)

Rapid 30’: this programme is designed to wash lightly soiled garments at

30° (excluding wool and silk) with a 3 kg maximum load in a short time: it

only lasts 30 minutes and allows for saving time and energy.

Cotton 90°+P: suitable for resistant linen and cotton that are heavily soiled.

Standard Cotton 60°C: suitable for washing moderately soiled cotton

garments. At 60°C it is the standard cycle for washing cotton garments,

and is the most ecient in terms of combined water and electricity

consumption.

Synthetic: suitable for washing moderately soiled garments made of

synthetic bres (e.g. polyester, polyacrylic, viscose, etc.) or mixed

synthetic-cotton bres.

Coloured: a 30°C cycle that helps to preserve colours, suitable for cotton

or synthetic coloured garments. It allows for reducing electricity

consumption for heating the water while guaranteeing good washing

results. Suitable for lightly soiled garments.

Eco Cotton 20°: ideal for lightly soiled cotton loads. The eective

performance levels achieved at cold temperatures, which are comparable

to washing at 40°, are guaranteed by a mechanical action which operates

at varying speed, with repeated and frequent peaks.

Eco Synthetic: ideal for mixed loads (cotton and synthetics) with a

normal soil level. The eective performance levels achieved at cold

temperatures are guaranteed by a mechanical action which operates at

varying speed, across set average intervals.

Wash&Dry 45’: select programme 13 for washing and drying lightly

soiled garments (Cotton and Synthetic) in a short time. This cycle may be

used to wash and dry a laundry load of up to 1 kg in just 45 minutes. To

achieve optimum results, use liquid detergent and pre-treat cus, collars

and stains.

AirFresh: ideal cycle to refresh garments and remove bad odours, in

particular smoke, from cotton and synthetic items in 30’ (max. 1,5 kg)

without the washing phase.

Rinse/Bleach: designed for rinsing and bleaching.

Spin + Drain: designed to spin and drain the water.

DISPLAY

The display is useful when programming the machine and provides a lot

of information.

The duration of the available wash cycles and the remaining time of a

running cycle appear in section A; if the Delayed Start option has been

set, the countdown to the start of the selected cycle will appear.

Pressing the corresponding button allows you to view either the

maximum spin speed, temperature and drying time values attained by

the machine during the set wash cycle, or the values selected most

recently (if compatible with the set wash cycle).

The hourglass ashes while the machine processes the data on the basis of the

selected cycle. After a maximum of 10 minutes, the icon remains steady lit

and the nal time remaining is displayed. The “hourglass” icon will then switch

o approximately 1 minute after the nal time remaining has been displayed.

The “washing phases” relative to the selected cycle and the “washing

phase” of the running cycle appear in section B:

Wash

Rinse

Spin/ Drain

Drying

When lit, the symbol indicates that the set “Delayed Start” value has

appeared on the display.

There are three levels in section C relative to the washing options.

Section D includes the icons related to the three dierent drying levels as

well as the icon , which lights up when a timed drying option is set.

Door locked indicator

When lit, the symbol indicates that the door is locked. To prevent any

damage, wait until the symbol turns o before opening the door.

To open the door while a cycle is in progress, press the START/PAUSE

button ; if the symbol is o, the door can be opened.

FIRSTTIME USE

Once the appliance has been installed, and before it is used for the rst

time, run a wash cycle with detergent and no laundry, by setting the

“Auto-Clean” cycle.

DAILY USE

Prepare the laundry by following the suggestions appearing under the

“TIPS AND SUGGESTIONS” section.

Rapid programming

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the cycle table.

- Pull out the detergent dispenser drawer and pour the detergent into the

relevant compartments as described in “DETERGENT DISPENSER DRAWER”

section.

- Close the door.

- Press the PUSH & WASH + DRY button to start the wash cycle.

Traditional programming

- Press the ON/OFF button ; the START/PAUSE indicator light will

ash slowly green.

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the Wash Cycle Table.

- Pull out the detergent dispenser drawer and pour the detergent into the

relevant compartments as described in “DETERGENT DISPENSER DRAWER”

section.

- Close the door.

- Use the WASH CYCLE selector knob to select the desired wash cycle: it

will be associated with a specic temperature and spin speed that can be

modied. The duration of the cycle will appear on the display.

- Modify the temperature and/or spin speed: the machine automatically

displays the maximum temperature and spin speed values set for the

selected cycle, or the most recently-used settings if they are compatible

with the selected cycle. Pressing the button gradually reduces the

temperature down to the cold wash “OFF” setting. Pressing the button

gradually reduces the spin speed until it is completely excluded (“OFF”

setting). Pressing these buttons again restores the maximum values.

- Select the desired options.

- Press the START/PAUSE button to start the wash cycle; the relative

indicator light will light up steady green and the door will lock ( symbol on).

PAUSING A CYCLE

To pause the wash cycle, press the START/PAUSE button again; the

indicator light will ash amber. If the symbol is not lit, the door may be

opened. To start the wash cycle from the point at which it was

interrupted, press the START/PAUSE button again.

OPENING THE DOOR, IF NECESSARY

Once a cycle starts, the symbol turns on to signal that the door cannot

be opened. While a wash cycle is running, the door remains locked. To

open the door while a cycle is under way, for example, to add or remove

garments, press the START/PAUSE button to pause the cycle; the

indicator light will ash amber. If the symbol is not lit, the door may be

opened. Press the START/PAUSE button again to continue the cycle.

CHANGING A RUNNING WASH CYCLE

To change a wash cycle while it is in progress, pause the washer-dryer using the

START/PAUSE button (the relative indicator light will ash amber), then

select the desired cycle and press the START/PAUSE button again.

! To cancel a cycle that has already begun, press and hold the ON/OFF

button. The cycle will be stopped and the machine will switch o.

END OF THE CYCLE

This will be indicated by the word “END” on the display; when the symbol

switches o, the door may be opened. Open the door, unload the laundry

and switch o the machine. If you do not press ON/OFF button, the

washer-dryer will switch o automatically after about a half of an hour.

Indesit XWDE 961480X Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Indesit XWDE 961480X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info