Bedienungsanleitung Kalorik KA CEH 14 (Seite 5 von 12) (Englisch, Portugiesisch)

491046

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don‟t change the page numbering. Keep the

language integrity.

5 KA CEH 14 - 070523

Assembly page 5/12

Fax +32 2 359 95 50

 Do not use double adapters or other appliances to connect with heater.

(*)

Competent qualified service: after sales department of the producer or importer or any

person who is qualified, approved and competent to perform this kind of repairs in order to

avoid all danger. In any case you should return the appliance to this service.

POSITIONING OF THE APPLIANCE

The heater should only be operated at a minimum distance of 50cm from any wall or other

object. Position the air flow in order to optimise the heating of the room. Avoid corners, small

volumes, floors and ceilings.

BATTERIES

 In order to be able to use the remote control, you first have to insert the batteries in it. To

do so:

 Open the battery compartment.

 Insert the batteries, making sure you respect the + and – polarity.

 Close the compartment. Use 2 AAA-type batteries of 1.5 V. Never mix up new and old

batteries or batteries of different types.

 When you decide to throw away the appliance, make sure to remove the battery and to

dispose of it in an ecological manner by handing it in a place intended for this end.

Caution: if you don’t use your remote control for a long time, it is recommended to remove the

batteries because they could run.

USE

When the appliance is switched on for the first time, a slight smell may be emitted. Please

ensure sufficient ventilation. This smell will disappear very quickly.

The heater may be operated by the manual controls located on the heater or by your remote

control.

1. Place the heater on a firm level surface.

2. Plug in the appliance. Press the main power switch to „ON‟ position. A beep will sound

indicating that there is power to the unit. The heater is ready for use.

3. Turn the heater ON by pressing the “ON/OFF” button of the remote control or control

panel. The unit will display the current room temperature.

4. Upon turning the heater on, the unit will be in the low heat mode. The LCD screen will

display “1000W” and the symbol will flash.

NOTE: If the room temperature is higher of 1°C than the set temperature, the heater will

switch to fan mode after 10 seconds.

5. The symbol will always be displayed indicating that the negative ion generator is

working.

6. To set the temperature, press the “MODE” button of the control panel or remote control

until the information “SET” “TEMP” and “20°C” flash in the upper right hand frame. Then

press the “+” and “-” buttons of the remote control or control panel to set the temperature

between 15 and 35°C.

NOTE: When the set temperature is lower than the actual room temperature, the unit will

automatically stop heating and switch to fan mode (cool wind). When the room

temperature will get lower than the set temperature, the unit will start heating again, and

so on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik KA CEH 14 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info