Bedienungsanleitung Kalorik KA CEH 14 (Seite 6 von 12) (Englisch, Portugiesisch)

491046

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don‟t change the page numbering. Keep the

language integrity.

6 KA CEH 14 - 070523

Assembly page 6/12

Fax +32 2 359 95 50

7. To turn on the heat mode, press the “LEVEL” button until and 1000W (low heat

mode) or and 2000W (high heat mode) are displayed on the LCD screen. If none of

these symbols are displayed, the unit will not start heating.

8. To turn the heater OFF, press the “ON/OFF” button of the remote control or control panel.

The set temperature will be saved for next use, i.e. the next time you will switch on your

heater, it will start heating directly at the previously set temperature.

NOTE: If you press the main power button located on the back of the unit, this memory

function will not work and the heater will start at the usual preset temperature (20°C).

Swing function

This function will work in any mode. Pressing the “SWING” button will allow the heater to

oscillate left and right. The symbol will flash on the screen indicating the swing function is

on. To stop the oscillation, press the swing button once more.

Timer function

This function will work in any mode. The timer function allows you to set the length of operation

from 1 hour to 23 hours. To set the timer, press the MODE button until “00” flashed in the lower

right hand side frame of the screen. Then press the “+” and “-” buttons of the remote control or

control panel to set the timer from 1h to 23h. Once the timer has been set, the timer will count

down the hours in 1 hour increments, showing on the display the remaining operating time until

the heater will turn off. Pressing the “+” button once more after the display shows 23 hours will

reset the heater to continuously running.

SAFETY DEVICES

 Your appliance is fitted with a safety device (tip-over switch situated on the bottom of the

appliance) that disconnects your appliance when it is tilted or tipped. If your appliance

falls, switch it off, replace it correctly and switch it on again.

 This heater is also protected with an overheat protection that switches off the appliance

automatically in case of overheat, e.g. due to the total or partial obstruction of the grids.

In this case, unplug the appliance, wait about 15-20 minutes for it to cool and remove the

object that is obstructing the grids. Then switch it back on as described above. The

appliance should operate normally. Should the problem persist, please contact the

nearest customer service.

MAINTENANCE AND CLEANING

 Before cleaning the appliance, ensure it is disconnected from the power supply and has

cooled down completely.

 The housing may be wiped with a slightly damp, lint-fee cloth; do not use any abrasive

scouring pad or steel wool.

 The grids are particularly delicate; to clean them you can carefully use a vacuum cleaner.

 When you do not use the appliance, place it in a dry environment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik KA CEH 14 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info