Bedienungsanleitung Katadyn Hiker Pro Water Microfilter (Seite 4 von 8) (Englisch)

522398

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

NORMAL OPERATION

1. Place input hose in untreated water source. Adjust the float to keep prefilter off the bottom

and away from sediment.

2. Insert the EasyFill Bottle Adaptor into a clean water container or connect hydration conec-

tor to bladder*. (Figure 2-1, 2-2)

3. Make sure the hoses are not kinked. Begin pumping the handle in a slow, steady manner.

Approximately 48 strokes per minute equals 1 liter of water.

4. After filling water container with filtered water, remove bottle adaptor/hydration connector

from container/bladder and prefilter from water source. Continue pumping to remove

remaining water from pump body.

5. Store unit in the carry bag. To prevent the possibility of cross contamination, remove the out-

put hose and EasyFill Bottle Adaptor and store separately in the re-sealable bag inside the

carry bag.

*Note: Before each use, flush and discard a small amount (5 – 10 strokes) of water to remove

stale taste.

FIELD PERFORMANCE TIPS

The Katadyn Hiker Pro is designed to remove bacteria and protozoan cysts such as Giardia and

Cryptosporidium. To extend cartridge life, always use the best water source available. Keep the

intake prefilter clean and off the bottom. In heavy sediment conditions, wrap a coffee filter or ban-

danna around the intake prefilter. Where possible, place untreated water in container and wait

for sediment to settle out until water appears clear - then filter from water above the sediment.

Maintain your Katadyn water system to keep it operating smoothly.

1. If handle is hard to push:

Lubricate pump handle o-ring. Silicone lubricant is provided with your new unit. Remove

handle collar and handle. (Figure 1-1) Clean excess build-up from black rubber

o-ring on bottom of handle. Place a small amount of silicone lubricant all the way around

the o-ring. Re-assemble.

Clogged cartridge. A clogged cartridge requires replacement. As a temporary solution in

the field, remove the cartridge and swish it around in water. See also Hiker Pro removable

Filter Protector. Take care that untreated water does not contact the cartridge output barb. If

flow is not restored, replace cartridge. See Cartridge Installation for cartridge removal.

2. If unit pumps easily, but no water flow:

Make sure prefilter is submerged.

Make sure that hoses are not blocked or pinched.

Clean check valve. Occasionally, sediment may enter pump body and prevent check valve

from operating properly. This may cause lack of water draw. The check valve can

easily be cleaned to restore maximum water output. Remove the cartridge. Fill the pump

housing half way with water, swirl around and discard water. Fill the housing half way with

water again and reinstall cartridge. Pump slowly to get water started and resume normal

pump rate when flow has begun.

3. Prefilter: Rinse the prefilter in water to remove any particles that may be caught in the

strainer. For a more thorough cleaning, remove the prefilter from the input hose and clean

with water and a soft brush. Reassemble. Apply a small amount of silicone lubricant to the

strainer barb to ease assembly. (Figure 1-2)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Katadyn Hiker Pro Water Microfilter Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Katadyn Hiker Pro Water Microfilter

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info