511254
8
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
8
C-BX3
Getting started (continued)
Connecting the DC power cord
1 Insert the DC power cord into the hole on the center of the
stand base.
2 Lace the DC power cord into the groove at the bottom of the
stand base. Then, stick the supplied adhesive tapes at the
recommended positions (as illustrated below) to hold the
power cord.
3 Align the DC power cord in between the side columns.
4 Connect the AC adapter to the DC IN jack on the rear of the
unit.
5 Plug the AC power cord (supplied) into a wall outlet.
¤ CAUTION
Make sure the DC power cord is firmly laced in the groove, otherwise, it
may cause the stand to be unstable.
Disconnect the power cord before cleaning or moving the unit.
Do not place the AC adaptor in the column.
To avoid the risk of fire and to prevent damage,
Do not use any AC adaptors other than the one supplied.
Do not use the supplied AC adaptor for other equipment.
Rear of the unit
Wood pin
Wood pin
Side columns
Stand base
To a wall outlet
AC adaptor (supplied)
Basic operation
Turning on/off the power
Press .
A small amount of power is consumed even when the power is turned
off (standby mode). During standby mode, the STANDBY indicator
lamp on the front panel lights up. Unplug the power cord from the AC
outlet to turn the power off completely.
You can also turn on the power by pressing one of the input buttons
(DIGITAL1, DIGITAL2, ANALOG, or iPod 6).
Activating/deactivating APS (Auto Power
Save)
The System automatically turns off to save the power.
Press and hold APS.
Each time you press and hold the button for 2 seconds, Auto Power Save
is toggled on or off (APS ON or APS OFF scrolls on the display).
The System automatically turns off to save the power when one of the
following situations continues for 29 minutes:
For all sources:
When the volume is set to 0.
When muting is activated.
For DIGITAL 1/DIGITAL 2:
When the optical cord or coaxial cord is not connected, or there is
no signal.
For iPod:
When iPod is not connected to the unit.
Operations
Bottom of stand base
Adhesive tape
EN_C-BX3[E]f.indd 8EN_C-BX3[E]f.indd 8 7/4/12 9:44:42 AM7/4/12 9:44:42 AM
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood C-BX3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kenwood C-BX3

Kenwood C-BX3 Bedienungsanleitung - Deutsch - 12 seiten

Kenwood C-BX3 Bedienungsanleitung - Holländisch - 12 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info