633365
5
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
5
KAF-3010R/1010 (En)
Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown below.
[XS8␣ ] Mode : lets you combine F , f, and ƒ terminals
[SL16] Mode : for
terminals only
This unit corresponds to [XS8] and to [SL16].
÷ When all units in system control connection are set to [XS8] mode, set the SYSREM CONTROL selector switch on the rear to the
[XS8] side and connect.
÷ When all units in system control connection are set to [SL16] mode, set the SYSREM CONTROL selector switch on the rear to the
[SL16] side and connect.
The system control operations
Remote Control
The remote control supplied with this unit can also be used to control the other components in the system.
Automatic Operation (except [XR] equipment)
Automatically switches the input selector on the amp or receiver when you start playback from this unit.
Synchronized Recording (except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD, MD, or LD.
Notes
Notes
The system control connections
(only for KAF-3010R)
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for
system operations. If your equipment consists of this kind of combination, please
do not connect any system control cords, Even without system control cords,
normal operations can be carried out without affecting performance.
2. If your amp or receiver does not have a system control terminal, do not connect
any system control cords to the system control terminals on the other compo-
nents.
3. Do not connect system control cords to any components other than those speci-
fied by KENWOOD. It may cause a malfunction and damage your equipment.
4. Be sure the system control plugs are inserted all the way in to the system control
terminals.
ƒ
SL 16 XS-8
+––+
PHONO CD TUNER TAPE
SYSTEM CONTROL
SPEAKERS
AC OUTLETS
UNSWITCHED
100W MAX.
SWITCHED TOTAL
200W MAX.
i
A or B : 4–16, A and B : 8–16
j
REC PLAY REC PLAY
MD
SIGNAL GND
L
R
L R
L R
B
A
ƒ
SL 16 XS-8
SYSTEM CONTROL
SYSTEM CONTROL
selector switch
No matter to which of the two terminals
the connection is made, the use method is
the same.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood KAF-3010R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info