Instructions for use
12
changes from “0” to “4”. If starting with the “-“
button, the cooking level changes from “0” to “9”.
Switching off a cooking zone
a) Pressing the “+” and “-” buttons of the desired
cooking zone at the same time.
b) Selecting cooking level “0” of the desired
cooking zone with the “-” button.
If the last cooking zone is switched off, the control
switches to the OFF mode after 10 sec. if nothing
else is switched on.
All cooking zones are switched off immediately by
pressing the ON/OFF button.
Cooking and power levels
The cooking and power levels of the cooking zones
are shown on the display with 7 allotted segments.
In accordance with standards, the power levels are
displayed with numbers from “1” to “9”.
Residual heat indicator
Indicates to the user that the glass is at a dangerous
temperature if in contact with the area over the
cooking zone. The temperature is determined by
means of a mathematical model and possible
residual heat is indicated by “H” on the
corresponding 7 segment display.
Heating and cooling are calculated based on:
- The selected power level (from “0” to “9”);
- The relay activation time after the cooking zone
has been switched off.
The corresponding display shows “H” until the
zone temperature drops below the critical level (<
60 °C) according to the mathematical model.
Control panel lock
Activation and deactivation Pressing the key-
lock button in standby or active mode locks the
keypad and the key-lock LED will light. You can
only turn the power totally off with the On/Off
button or unlock the keypad by pressing the key
lock symbol and, after the beep, the symbol.
The activation of the key-lock in the pause or
active mode causes the deactivation of the power to
both burners.
The symbol “11” appears on the display. It can
only be totally turned off with the ON/OFF button
or the release by activating the key-lock symbol
and then the “+” o “-” symbol a er the beep.
Booster and management of power for the wok
induction model
The wok induction model has a Booster function.
The generator, with Booster On, gives the cooking
zone power that is significantly greater than the
rated output.
The booster allows a particularly rapid heating of
the food thereby saving the user time.
The Booster function can be activated pressing the
“P” (power booster) button:
The power is increased from 2400 to 3000 W.
For safety reasons the Booster function can only be
activated for a limited duration of 10 minutes.
If the pan is removed from the cooking zone during
the Booster time, the Booster function remains on
and also the Booster time is not deactivated.
Precautions
- If there is even the tiniest crack in the ceramic
glass surface, immediately disconnect the hob
from the electricity supply.
- During operation, move any magnetic materials
such as credit cards, computer disks, calculators,
etc., away from the area.
- Never use cooking foil or rest products wrapped
in foil directly on the hob.
- Metallic objects such as knives, forks, spoons
and lids must not be rested on the surface of the
hob to prevent them from heating up.
- When cooking with non-stick containers,
without using water or oil, limit any preheating
time to one or two minutes.
- When cooking foods which tend to stick to the
bottom of the pan, start at minimum power and
gradually increase the heat, stirring frequently.
- After use, switch off correctly (decreasing to
“0”) and avoid relying on the pan sensor.
1. Vassel
2. Induced current
3. Magnetic field
4. Inductor
5. Electronic circuit
6. Power supply
