Bedienungsanleitung Konig Electronic HC-BM05 (Seite 3 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch, Finnisch)

508657

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

To use with mains power

Both transmitter and receiver can be operated by AC adapters (provided).

Insert the adapter plug into the DC jack at the bottom of transmitter and/or receiver. Then plug the

adapter into the main socket.

To use with battery

For portable use, the receiver can be operated with 3 x 1.5 V standard AAA size alkaline batteries.

Open the battery compartment of the unit by removing the screws on the cover. Insert the batteries

according to the correct polarity. Close the cover properly with the screws.

The power LED light will turn RED when the battery power level is low. Always remove the batteries

when the unit is not being used for long periods.

Note: The maximum operating time using batteries is two days depending on the frequency of

noise transmissions. The range may be restricted during battery operation.

Rechargeable function on receiver

Only the receiver can use the supplied rechargeable batteries. The transmitter does not have the

rechargeable function. When the mains adapter is connected to the receiver, the batteries supplied are

automatically charged. It takes about 8 hours to fully charge the batteries. As long as the battery power

is sufficient for reliable operation, the power LED remains “GREEN”.

Note: Only the rechargeable batteries supplied may be recharged. DO NOT attempt to recharge

using commercially available batteries.

CHANGING THE BATTERIES

Insert 3 x AAA size alkaline batteries into the battery compartment of the unit according to the polarity

of the batteries (as instructed above).

The power LED light turns “GREEN” when new/fully charged batteries are used.

The power LED light turns “RED” when the batteries are flat.

For extended use, it is advisable to power the units using the AC adapters provided.

OPERATION

Channel setting

This baby monitor has two channels, A and B. Both units are pre-set to channel A in advance by the

manufacturer.

Open the battery compartment of the transmitter and receiver by removing the screw on the cover.

The channel switch has been positioned in the battery compartment to prevent unintentional channel

adjustment.

The channel selection switch setting must be the same for both units.

If other voices or sounds can be heard on the receiver using the selected channel, the channel switch

should be set to another channel to avoid interference.

The transmitter (Baby unit)

• Place the transmitter at least 2 metres away from the baby for optimum voice detection.

• Select channel A or B for transmission with the channel switch.

• Turn on the transmitter with the HI/LOW/OFF switch at the side of the transmitter. The power LED

light should be turned ON.

• Switch to the HI position to set the microphone sensitivity to high level. Move the slide switch to the

LOW position for low level of microphone sensitivity.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Konig Electronic HC-BM05 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info