Bedienungsanleitung Kuppersbusch EEB 9550.0 (Seite 14 von 14) (Englisch)

513471

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

EEB 9550.0 31

Rating label

The rating label for the oven is located

on the right-hand side strip and is visible

when the oven door is open.

Always indicate the data provided on the

rating label when calling in Customer

Service or ordering spare parts.

– Make a note of this information in case you have to consult our customer

service.

Installation instructions for fitter

■ Only KÜPPERSBUSCH built-in hobs were designed and tested for use above

a Küpperbusch fitted oven. No other hobs may be used.

■ Statutory regulations and the connection specifications issued by the local

power supply company must be strictly observed.

■ When carrying out repairs the unit must be disconnected from the mains.

Disconnect the appliance from the mains, disconnect fuse.

■ It must not be possible to touch components which are insulated under ope-

rating conditions.

■ The unit is ready to plug in and may be connected only to a properly installed

protected socket. Installing and wiring a socket or replacing the connection

cable should only be performed by an electrician and in observance of the

relevant regulations.

■ If the socket is inaccessible after the installation, safety regulations require that

an all-polo isolator with a contact opening of at least 3 mm be used on the in-

stallation side.

■ The socket for plugging in the unit must be outside the installation space.

■ If you install the oven flush-left into the corner of an L-shaped divided kitchen,

you must maintain a distance of at least 15 cm to the left or the corner!

■ Built-in kitchen fixtures must be temperature resistant up to 100°C. This ap-

plies especially to veneers, plastic coatings, adhesives and varnishes. Adja-

cent cabinetry front must be temperature resistant to at least 70°C.

■ The unit must be installed absolutely horizontal on a level, solid base. The

base must not be allowed to sag.

■ If the cupboard element is not attached to the way, screw on using an or-

dinary bracket.

Installation dimensions

Electrics

[

WARNING! This appliance must be earthed!

Electrical requirements (for UK and Republic of Ireland only)

Check that the voltage stamped on the rating plate corresponds with your

house electricity supply, which must be AC (alternating current).

Electrical connection of the apppliance must be performed by a trained elec-

trician. The legally recognized regulations and the connection requirements of

the electricity board seving your area must be fully complied with.

[

WARNING! Should the oven be supplied with a continental two-pin plug

fitted, then this plug must be cut off from the connection cable. Dispose

of the plug safely; do not insert it in a 13 A socket elsewhere in the house

as this could cause a shock hazard.

Connection for UK and Republic of Ireland only: Permanent connection

to an oven power point (fuse: 20 A!).

Other countries:

Connection is via the mains plug into a wall socket.

Total rating at 230 V: 3.5 kW,

at 235 V: 3.6 kW

Electrical connection 230 - 240 V, 50 Hz

Fuse current 16 A

Installation in a fitted kitchen

The included clips are installed on both sides of the unit; these clips snap into

mounted support brackets in the cupboard element. The support brackets are

supplied with the unit. They must be mounted before installing the unit on

both cabinet inner sides as shown in the following illustrations:

– Place the support bracket 280 mm

from the bottom edge of the cabinet

with the raised parts towards the ca-

binet, mark and drill the rear

holes (1).

– Slide support bracket so that the front

holes lie over the drilled holes.

– Use screws supplied to fasten the

support bracket to the cabinet.

– Screw clips to the side walls.

– Insert power plug and

slide unit into cabinet ope-

ning into it snaps into pla-

ce. Be careful not to pinch

the power cable! The ca-

ble is not permitted to

come into contact with the

back or floor of the unit

once it is installed.

Production-no.

Model designation oven

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kuppersbusch EEB 9550.0 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kuppersbusch EEB 9550.0

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info