Bedienungsanleitung Lenco cr 334 (Seite 3 von 13) (Englisch)

455819

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

Before Setting Up the Unit

• Operate controls and switches as described in the manual.

• Before turning on the power, make certain that the power cord is properly installed.

• When moving the set, be sure to first disconnect the AC power cord.

• Avoid installing this unit in places exposed to direct sunlight or close to heat radiating

appliances such as electric heaters, on top of other stereo equipment that radiates too much

heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or

humid or moist areas.

Unpacking and Setting Up

• Remove the product from the carton and remove all packing material from the unit. We

suggest that you save the packing material, if possible, in the unlikely event that your unit

ever needs to be returned for service. The original carton and packing material is the only

safe way to pack your product to protect it from damage in transit.

• Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove

any labels or stickers from the back or bottom of the cabinet.

• Place your unit on a level surface such as a table, desk or shelf, convenient to an AC outlet,

out of direct sunlight, and away from sources of excess heat, dirt, dust, moisture, humidity, or

vibration.

• Unwind the FM antenna and extend it to its full length. It must be fully extended to provide

the best FM reception.

Protect Your Furniture

This model is equipped with non-skid rubber 'feet' at the bottom of the unit to prevent the product

from moving when you operate the controls. These 'feet' are made from non-migrating rubber

material specially formulated to avoid leaving any marks or stains on your furniture. However

certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the

rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any

damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads,

available at hardware stores and home improvement centers everywhere, and apply these pads to

the bottom of the rubber 'feet' before you place the product on fine wooden furniture.

Power Source

This product is designed to operate on normal 230V 50Hz AC power only. Do not attempt to

operate the unit on any other power source. You could cause damage to the product that is not

covered by your warranty.

This unit should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet

that is controlled by a wall switch. When the power to the unit is interrupted, the built in lithium

battery takes over to maintain the time and alarm settings. To maximize the life of the lithium

battery keep the unit connected to a ‘live’ AC outlet at all times.

AC Plug AC Outlet

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lenco cr 334 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Lenco cr 334

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info