Bedienungsanleitung Makita ST113D (Seite 5 von 60) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

657961

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

5 ENGLISH

5. Use caution while removing a jammed fas-

tener.Themechanismmaybeundercompression

andthefastenermaybeforcefullydischarged

whileattemptingtofreeajammedcondition.

6.

Do not use this stapler for fastening electrical

cables.Itisnotdesignedforelectriccableinstallation

andmaydamagetheinsulationofelectriccables

therebycausingelectricshockorrehazards.

Always wear safety goggles or safety glasses with

side shield, and a full face shield when needed.

8. Keep hands and feet away from the ejection

port area.

9. Always remove the battery cartridge before

loading the fasteners, adjustment, inspection,

maintenance or after operation is over.

10. Make sure no one is nearby before operation.

Never attempt to drive fasteners from both the

inside and outside of wall at the same time.

Fasteners may rip through and/or y off, pre-

senting a grave danger.

11. Watch your footing and maintain your balance

with the tool. Make sure there is no one below

when working in high locations.

12. Check walls, ceilings, oors, roong and

the like carefully to avoid possible electrical

shock, gas leakage, explosions, etc. caused by

stapling into live wires, conduits or gas pipes.

13. Use only fasteners specied in this manual.

The use of any other fasteners may cause

malfunction of the tool.

14. Do not tamper with the tool or attempt to use it

for other than driving fasteners.

15. Do not operate the tool without fasteners. It

shortens the service life of the tool.

16. Stop driving operations immediately if you

notice something wrong or out of the ordinary

with the tool.

17. Never fasten into any materials which may

allow the fastener to puncture and y through

as a projectile.

18.

Never actuate the switch trigger and contact ele-

ment until you are prepared to fasten workpieces.

Never defeat its purpose by securing the contact

element back or by depressing it by hand.

19. Never tamper with the contact element. Check

the contact element frequently for proper

operations.

SAVE THESE INSTRUCTIONS.

WARNING: DO NOT let comfort or familiarity

with product (gained from repeated use) replace

strict adherence to safety rules for the subject

product. MISUSE or failure to follow the safety

rules stated in this instruction manual may cause

serious personal injury.

Important safety instructions for

battery cartridge

1. Before using battery cartridge, read all instruc-

tions and cautionary markings on (1) battery

charger, (2) battery, and (3) product using

battery.

2. Do not disassemble battery cartridge.

3. If operating time has become excessively

shorter, stop operating immediately. It may

result in a risk of overheating, possible burns

and even an explosion.

4. If electrolyte gets into your eyes, rinse them

out with clear water and seek medical atten-

tion right away. It may result in loss of your

eyesight.

5. Do not short the battery cartridge:

(1) Do not touch the terminals with any con-

ductive material.

(2) Avoid storing battery cartridge in a con-

tainer with other metal objects such as

nails, coins, etc.

(3) Do not expose battery cartridge to water

or rain.

A battery short can cause a large current

ow, overheating, possible burns and even a

breakdown.

6. Do not store the tool and battery cartridge in

locations where the temperature may reach or

exceed 50 °C (122 °F).

7. Do not incinerate the battery cartridge even if

it is severely damaged or is completely worn

out. The battery cartridge can explode in a re.

8. Be careful not to drop or strike battery.

9. Do not use a damaged battery.

10.

The contained lithium-ion batteries are subject to

the Dangerous Goods Legislation requirements.

For commercial transports e.g. by third parties,

forwardingagents,specialrequirementonpack-

aging and labeling must be observed.

Forpreparationoftheitembeingshipped,consult-

inganexpertforhazardousmaterialisrequired.

Pleasealsoobservepossiblymoredetailed

national regulations.

Tapeormaskoffopencontactsandpackupthe

battery in such a manner that it cannot move

around in the packaging.

11. Follow your local regulations relating to dis-

posal of battery.

SAVE THESE INSTRUCTIONS.

CAUTION: Only use genuine Makita batteries.

Useofnon-genuineMakitabatteries,orbatteriesthat

have been altered, may result in the battery bursting

causingres,personalinjuryanddamage.Itwill

alsovoidtheMakitawarrantyfortheMakitatooland

charger.

Tips for maintaining maximum

battery life

1. Charge the battery cartridge before completely

discharged. Always stop tool operation and

charge the battery cartridge when you notice

less tool power.

2. Never recharge a fully charged battery car-

tridge. Overcharging shortens the battery

service life.

3. Charge the battery cartridge with room tem-

perature at 10 °C - 40 °C (50 °F - 104 °F). Let

a hot battery cartridge cool down before

charging it.

Makita ST113D Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info