Bedienungsanleitung Makita ST113D (Seite 7 von 60) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

657961

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

7 ENGLISH

ASSEMBLY

CAUTION: Always make sure that the battery

cartridge is removed before carrying out any work

on the stapler.

Staples

CAUTION: Do not use staples other than

designated in this manual or staples that appear

to be damaged, bent, rusty or corroded.

CAUTION: Load the same type, size and

uniform length of staples when loading multiple

strips of staples in the magazine.

NOTICE: Handle the staples and their box care-

fully. If the staples have been handled roughly,

they may be bent out of shape, causing poor

staple feed or jamming.

NOTICE:

Avoid storing the staples in a very humid

or hot place or place exposed to direct sunlight.

Loading staples

WARNING: When loading staples, always

make sure that the battery cartridge is removed

from the stapler.Unintentionalringmaycause

personalinjuriesandpropertydamage.

CAUTION:

After loading staples, make sure that

the sub magazine is surely closed. Falling staples out

ofthemagazinemaycauseaninjurytotheoperatoror

bystander, especially when working in high locations.

1. Remove the battery cartridge.

2. Pressthelockingleverandslidethesubmaga-

zine backward.

►Fig.6: 1. Locking lever 2. Sub magazine

3. Load staples into the main magazine with their

feetfacingup.

►Fig.7: 1. Staples 2.Mainmagazine

4. Afterloadingstaples,pushbackthesub-maga-

zine in place until it clicks.

Toremovestaples,followtheinstallationproceduresin

reverse.

Hook

CAUTION: Do not hang the hook from the

waist belt. Dropping the stapler, which is caused by

thehookaccidentallycomingoutofplace,maycause

unintentionalringandresultinpersonalinjuries.

►Fig.8

Thehookisconvenientfortemporarilyhangingthetool.

Thiscanbeinstalledoneithersideofthetool.

Toinstallthehook,insertitintoagrooveinthetool

housing on either side and then secure it with a screw.

Toremove,loosenthescrewandthentakeitout.

►Fig.9: 1. Groove 2. Hook 3. Screw

OPERATION

Testing the safety system

WARNING: Make sure all safety systems are

in working order before operation. Failure to do

so may cause personal injuries.

►Fig.10: 1.Trigger-lockbutton2. Switch trigger

3. Contact element 4. Sub magazine

Testsafetysystemsforpossiblefaultbeforeoperation

asfollows.

1. Unloadstaplesfromthetoolandkeepthesub

magazine opened.

2. Install the battery cartridge.

3. Only pull the switch trigger without touching the

contact element against the material.

4. Only touch the contact element against the mate-

rial without pulling the switch trigger.

Ifthetooloperatesinthecaseof3and4above,the

safetysystemsarefaulty.Stopusingthetoolimmedi-

ately and ask your local service center.

Driving staples

WARNING: Continue to place the contact

element rmly on the material until the staple is

driven completely.Unintentionalringmaycause

personalinjuries.

►Fig.11: 1. Switch trigger 2. Contact element 3. Front

part 4. Rear part

Youcanoperatethetoolineitherwayof“single

sequentialactuation”or“contactactuation”.

Single sequential actuation:

Inthismode,youcandriveonestaplebyonesequen-

tial operation.

1. Placeatthecontactelementonthematerial.

2. Holdbothofthefrontpartandtherearpartofthe

toolrmlyagainstthematerial.

3. Pulltheswitchtriggerfullytodrivethestaples.

4. Releaseyourngerfromtheswitchtriggerbefore

movethecontactelementfromthematerial.

Contact actuation:

Inthismode,youcandrivestaplessequentially.

1. Pulltheswitchtrigger.

2. Withtheswitchtriggerpulled,placeatthecon-

tact element on the material to drive the staples.

3. Movethetooltothenextareaandplaceatthe

contact element on the material again.

NOTE:Thegrooveindicatesthepointthatstapleis

driven.

►Fig.12: 1. Groove

Iftheheadofthestapleremainsabovetheworkpiece

surface,drivethestaplewhileholdingthestaplerhead

rmlyagainsttheworkpiece.

►Fig.13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita ST113D Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info