Bedienungsanleitung Multiplex ROYALevo7 (Seite 74 von 77) (Englisch)

30268

Zoom out

Zoom in

Vorherige Seite

1/77

Nächste Seite

ROYAL evo 7 - Instructions

Page 73

ENGLIS

24. MULTInaut IV

channel expansion system

If the seven channels of the ROYALevo 7 are not suffi-

cient, perhaps for a complex multi-function model, the

MULTIPLEX MULTInaut IV channel expansion system

can be used. The ROYALevo is capable of controlling

two MULTInaut IV receiver modules (# 7 5892) which

are available as optional accessories.

Each MULTInaut IV receiver module installed in the

model can control up to four consumer units (max. con-

tinuous load 4 x 4A / 16V) and/or up to four servos in

various modes of operation. One channel is required to

actuate one MULTInaut IV receiver module. If you use

two MULTInaut IV receiver modules a total of 13 chan-

nels are available to you (five proportional channels plus

2 x 4 MULTInaut channels).

Preparation

Move to the menu

Servo / Assignment (Î 16.2.)

and determine which channels (receiver outputs) are to

be used for the control signals of the two MULTInaut IV

receiver modules:

M.naut1 or M.naut2

The receiver modules in the model must be connected

to the corresponding channels.

The MULTInaut system is only available for the

fixed-wing model type!

Activating the MULTInaut mode of operation:

The keypad of the ROYALevo is used to control the

MULTInaut functions (no additional or special switches

have to be installed). Starting from one of the three

status displays, hold the ENTER button held in for

longer than three seconds; this activates the button

groups for MULTInaut use. The screen display is as fol-

lows:

Note:

If the MULTInaut mode of operation is active and the

MULTINAUT display is on the screen, it is not possible to

use the keypad (or the 3D digi-adjustors) to make

changes in any of the menus.

Hold ENTER pressed in again for longer than three sec-

onds to end this mode of operation.

Operating the MULTInaut channels

In each case four buttons (group of buttons) are as-

signed to one MULTInaut channel, and control the con-

sumer units or servos connected to the receiver module.

The effect of one button-press varies according to the

system controlled by the MULTInaut channel. The fol-

lowing alternatives are available:

a. Consumer units to terminals +/-1 to +/-4

The diagram shows where the consumer units

have to be connected.

Diagram for servo 5 =

M.naut1

For switching consumers (e.g. lamps, horns etc.).

Every time you press a button briefly the associ-

ated load is switched from one state to the other:

(OFF Æ ON or ON ÆOFF)

b. Servo to sockets 1 to 4, no jumper

If the jumpers (bridging plugs) are not connected

to servo sockets 2 and 4, the servo moves from one

end-point to the other every time you press the as-

sociated button.

c. Servo to socket 1 / 3

to servo socket 2 / 4 with jumper

Buttons 1 and 2 control the servo at socket 1; but-

tons 3 and 4 the servo at socket 3. For as long as

the button is held pressed in the servo runs in one

direction until it reaches the end-point. When you

release the button, the servo stops.

The full servo travel is divided into 32 segments,

and takes about four seconds to traverse. One

short button-press triggers a step of about 3°.

Each MULTInaut IV module is supplied with detailed

operating instructions including all the information you

need to install and operate the system, together with a

full Specification.

Button group for

M.naut 1

e.g. servo 5 = M.naut 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex ROYALevo7 Seite 74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Multiplex ROYALevo7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info