Bedienungsanleitung MundoClima MUCSR-H6 - Model 24 to 60 (Seite 8 von 40) (Englisch)

726078

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

INSTALLATION MANUAL

Fig.5-5 Fig.5-4

Fig.5-9 Fig.5-8

1.3 Install The Panel

Remove the air-in grill.

Never put the panel face down on floor or against the

wall, or on bulgy objects.

Never crash or strike it.

Slide two grill switches toward the middle at the same time,

and then pull them up. (Refer to Fig.5-7)

Draw the grill up to an angle of about 45, and remove it.

(Refer to Fig.5-8)

Remove the installation covers at the four corners

Wrench off the bolts, loose the rope of the installation covers,

and remove them. (Refer to Fig.5-9)

CAUTION

Fig.5-6

Fig.5-7

1.2 Install the main body

Cut a quadrangular hole of 880x880mm in the ceiling

according to the shape of the installation paper board.

(Refer to Fig.5-2)

The center of the hole should be at the same position of

that of the air conditioner body.

Determine the lengths and outlets of the connecting pipe,

drainpipe and cables.

To balance the ceiling and to avoid vibration, please

enforce the ceiling when necessary.

Adjust the hexangular nuts on the four installation hooks

evenly, to ensure the balance of the body.

If the drainpipe is awry, leakage will be caused by the

malfunction of the water-level switch.

Adjust the position to ensure the gaps between the body

and the four sides of ceiling are even. The body's lower

part should sink into the ceiling for 10~12 mm (Refer to

Fig.5-4) .

In general, L is half of the screw length of the installation

hook. (Refer to Fig.5-4)

Locate the air conditioner firmly by wrenching the nuts

after having adjusted the body's position well. (Refer to

Fig.5-5)

Select the position of installation hooks according to the

hook holes on the installation board.

Drill four holes of

12mm, 45~50mm deep at the selected

positions on the ceiling. Then embed the expansible

hooks (fittings).

Face the concave side of the installation hooks toward the

expansible hooks. Determine the length of the installation

hooks from the height of ceiling, then cut off the

unnecessary part.

If the ceiling is extremely high, please determine the

length of the installation hook according to facts.

New built houses and ceilings

In the case of new built house, the hook can be embedded

in advance (refer to 2 mentioned above). But it should be

strong enough to bear the indoor unit and will not become

loose because of concrete shrinking.

After installing the body, please fasten the installation paper

board onto the air conditioner with bolts(M6X12) to

determine in advance the sizes and positions of the hole

opening on ceiling. (Refer to Fig.5-6)

Refer to 3 above for installation.

Remove the installation paper board.

Please first guarantee the flatness and horizontal of

ceiling when installing it.

Refer to 1 mentioned above for others.

After installing the body, the four bolts(M6x12)must be

fastened to the air conditioner onto ensure the body is

grounded well.

CAUTION

The existing ceiling (to be horizontal)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

MundoClima MUCSR-H6 - Model 24 to 60 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info