707510
42
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
E40
46.1 General Connections Notes
The negative input and output connections are all
common. The mains earth should always be connected
regardless of what other equipment is used. This only
grounds the case and the electrostatic screen within the
transformer, and is not connected to the signal negative.
In order to avoid hum loops, the signal negative of the
whole system should be connected to the mains earth
(ground) in one place.
46.2 Protection Notes
If the amplifier’s external case reaches 70°C due to
prolonged running at high power, the mains supply will be
interrupted and the illuminated logo will switch off until
the amplifier has cooled down. This may take up to thirty
minutes.
46 Installation and Operation
The NAP 155 XS should be installed on a dedicated equipment stand intended for the
purpose and should be in its final location before connecting cables or switching on.
Switch on the source and preamplifier components, with the volume turned down, before
switching on the NAP 155 XS. The NAP 155 XS power switch is located on the rear panel.
The NAP 155 XS can provide power for an appropriate Naim Audio preamplifier. The
power supply output is carried on the DIN input socket.
OPERATION OF THE AMPLIFIER’S THERMAL PROTECTION
SUGGESTS PROLONGED USE AT TOO HIGH A VOLUME LEVEL.
YOUR LOUDSPEAKERS MAY BE AT RISK IF THIS IS THE CASE.
THE VOLUME SHOULD BE REDUCED.
46.3 Loudspeaker Cable and Connectors
Only Naim Audio speaker cable should be used to
connect a loudspeaker to the output of the NAP 155 XS.
Custom Naim Audio loudspeaker connectors are supplied
to make the connection and in order to comply with
current European safety regulations these should always
be used.
DAMAGE TO THE AMPLIFIER MAY RESULT IF “HIGH
DEFINITION” CABLE OR ANY OTHER SPECIAL CABLE IS USED
TO CONNECT THE LOUDSPEAKERS.
Ensure when connecting speakers that they are “in
phase”. That is, the positive and negative connection
orientation at both the speaker and amplifier ends of the
cable is the same for both channels.
48 NAP 155 XS Specification
Power Output: 60 Watts per channel, 8Ω
250 VA Transient
Quiescent Consumption:
10VA
Voltage Gain:
+29dB
Input Impedance:
18kΩ
Frequency Response: -3dB @ 3Hz and 50kHz
Power Supply Output: 24V, 0.25A
Dimensions (H x W x D): 70 x 432 x 301mm
Weight 7.5kg
Mains Supply: 100-120V or 220-240V, 50/60Hz
mains input
and fuse
signal input
ch1(L) & ch2(R) and
preamp power
supply
ch2
ch1
24V
0.25A
Input/Preamp
Power Socket
-ve
power
switch
NAP 155 XS Power Amplifier
47 NAP 155 XS Connections
47.1 NAP 155 XS Rear
left
speaker
right
speaker
Note: The NAP 155 XS features various technologies to
reduce microphonic effects. Some movement of the
board and sockets when connecting and disconnecting
cables is normal.
42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Naim NAP 500 DR wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Naim NAP 500 DR

Naim NAP 500 DR Bedienungsanleitung - Deutsch - 44 seiten

Naim NAP 500 DR Bedienungsanleitung - Deutsch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Englisch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Holländisch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Französisch - 44 seiten

Naim NAP 500 DR Bedienungsanleitung - Französisch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Italienisch - 46 seiten

Naim NAP 500 DR Bedienungsanleitung - Italienisch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Spanisch - 16 seiten

Naim NAP 500 DR Bedienungsanleitung - Polnisch - 16 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info