Bedienungsanleitung Netgear HDX111 Powerline HD Plus Ethernet Adapter (Seite 3 von 38) (Englisch)

493238

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

v1.1, March 2008

iii

• Use the product only with approved equipment.

• Allow the product to cool before removing covers or touching internal components.

• Operate the product only from the type of external power source indicated on the electrical ratings label. If you are

not sure of the type of power source required, consult your service provider or local power company.

• To help avoid damaging your system, be sure that the voltage selection switch (if provided) on the power supply is

set to match the power available at your location:

- 115 volts (V), 60 hertz (Hz) in most of North and South America and some Far Eastern countries such as South

Korea and Taiwan

- 100 V, 50 Hz in eastern Japan and 100 V, 60 Hz in western Japan

- 230 V, 50 Hz in most of Europe, the Middle East, and the Far East

• Also, be sure that attached devices are electrically rated to operate with the power available in your location.

• Use only approved power cables. If you have not been provided with a power cable for your system or for any AC

powered option intended for your system, purchase a power cable that is approved for use in your country. The

power cable must be rated for the product and for the voltage and current marked on the product’s electrical ratings

label. The voltage and current rating of the cable should be greater than the ratings marked on the product.

• To help prevent electric shock, plug the system and peripheral power cables into properly grounded electrical

outlets.

• The peripheral power cables are equipped with three-prong plugs to help ensure proper grounding. Do not use

adapter plugs or remove the grounding prong from a cable. If you must use an extension cable, use a three-wire cable

with properly grounded plugs.

• Observe extension cable and power strip ratings. Make sure that the total ampere rating of all products plugged into

the extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the extension cable or

power strip.

• To help protect your system from sudden, transient increases and decreases in electrical power, use a surge

suppressor, line conditioner, or uninterruptible power supply (UPS).

• Position system cables and power cables carefully; route cables so that they cannot be stepped on or tripped over. Be

sure that nothing rests on any cables.

• Do not modify power cables or plugs. Consult a licensed electrician or your power company for site modifications.

• Always follow your local and national wiring rules.

• Move products with care; ensure that all casters and stabilizers are firmly connected to the system. Avoid sudden

stops and uneven surfaces.

Regulatory Notices

FCC Statement

The HDX111 has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the

FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Netgear HDX111 Powerline HD Plus Ethernet Adapter Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info