Bedienungsanleitung Netgear WGL102 (Seite 2 von 2) (Englisch)

519680

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

May 2, 2007

This symbol was placed in accordance with the European Union Directive

2002/96 on the Waste Electrical and Electronic Equipment (the WEEE

Directive). If disposed of within the European Union, this product should be

treated and recycled in accordance with the laws of your jurisdiction

implementing the WEEE Directive.

of NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or

registered trademarks of their respective holders. Information is subject to change without notice.

Compliance

Access Points are radio transmission devices and as such are subject to governmental regulation. Network

administrators responsible for the configuration and operation of Access Points must comply with local transmis-

sion regulations. Specifically, Access Points must use channel assignments appropriate to the location in which

the Access Point will be used.

WAGL102 or WGL102 Light Wireless Access Points are intended only for installation in Environment A as

defined in IEEE 802.3af, Power over Ethernet. All interconnected equipment must be contained within the same

building, including the interconnected equipment’s associated LAN connections.

When installed in an air-handling space, such as above suspended ceiling (plenum), the unit is required to be

powered via PoE only. Additional cabling such as Fast Ethernet (FE) cables installed in such spaces should be

suitable under NEC Article 800.50 and marked accordingly for use in plenums and air-handling spaces with

regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP.

FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

Supported

Frequency Bands

2.400 ~ 2.4835GHz (Global), 5.18 ~ 5.32 GHz, 5.745 ~ 5.825 GHz, channels

country specific

Supported

Operating

Channels

• 802.11b—US, Canada, Taiwan 11; ETSI up to 13; Japan 14

• 802.11g—US, Canada, Taiwan 11; ETSI up to 13; Japan 13

• 802.11a—US, Canada, Taiwan 13; ETSI up to 19; Japan 8

Output transmit

power

100 mW maximum (or lower as configured on the WFS709TP ProSafe Smart

Wireless Switch to comply with local regulatory requirements)

Radio band

selection

Via WFS709TP ProSafe Smart Wireless Switch in software manageability:

• Management of all 802.11 parameters

• Network wide AP management via WEB GUI and SNMPv3

• Access Point Profiles, managed by geographical location, BSSID and radio

type

Encryption 40bit / 64bit / 128bit / 152bit WEP, TKIP, AES

802.11b and g

Typical Receive

Sensitivity

• 802.11b mode at 1Mbps: -95 dBm; 802.11b mode at 2 Mbps: -93 dBm;

802.11b mode at 5.5 Mbps: -91dBm; 802.11b mode at 11 Mbps: -89 dBm;

• 802.11g mode at 6 Mbps: -91 dBm; 802.11g mode at 9 Mbps: -90 dBm;

802.11g mode at 12 Mbps: -89 dBm; 802.11g mode at 18 Mbps: -87 dBm;

802.11g mode at 24 Mbps: -84 dBm 802.11g mode at 36 Mbps: -81 dBm;

802.11g mode at 48 Mbps: -77 dBm; 802.11g mode at 54 Mbps: -75 dBm;

802.11g mode at 108 Mbps: -72 dBm

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harm-

ful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at their own expense.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate this equipment.

This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this device must accept any interference received, includ-

ing interference that may cause undesired operation.

RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits. This equipment should be installed and oper-

ated with a minimum distance of 20cm (7.9 inches) between the radiator and your body for 2.4 GHz and 5 GHz

operations. This transmitter must not be co-located or operating in conjunction with any other antenna or trans-

mitter.

This device when operated in the 5.15 to 5.25 GHz frequency range is restricted to indoor use to reduce the

potential for harmful interference to co-channel Mobile Satellite Systems.

Europe

Warning-This is a Class B product. In a domestic environment, this product may cause radio interference in

which case the user may be required to take adequate measures.

This product complies with 1999/5/EC, EN5022 Class B, and EN5024 standards.

Certifications

Electromagnetic Compatibility

IEC 60950 CB certificate and report

FCC DOC Part 15 Class B (digital portion)

FCC Part 15 Subpart C 15.247

FCC Part 15 Subpart E 15.407

RSS 210 (Canada)

CE marked with NB letter of opinion

— EN 300 328 2.4 GHz

— EN 301 893 5.4 GHz

AS/NZS 3548 Class B

AS/NZS4771 (C-tick)

Safety Compliance: IEC 60950; EN 60950

Plenum Use: Suitable for use in environmental air handling space in accordance with Section 300.22.C of the

National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1,

C22.1

Medical: EN 60601-1-1: 2001; EN 60601-1-2: 2001

Technical Support

Thank you for selecting NETGEAR products.

After completing installation, locate the serial number on the bottom label of the Light

Wireless Access Point and use it to register your product at

http://www.netgear.com/register.

Registration on the web site or over the phone is required before you can use our

telephone support service. The phone numbers for worldwide regional customer support

centers are on the Warranty and Support Information card that came with your product.

Go to http://www.netgear.com/support for product updates and web support.

Netgear WGL102 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info