Bedienungsanleitung One for All URC 8090 (Seite 20 von 22) (Englisch)

492763

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

COMPLIANCE WITH THE FCC RULES AND

REGULATIONS

This equipment has been tested and found to comply with the

limits for a class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and radiates radio frequency

energy and if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try and correct the interference

by one or more of the following measures:

* Reorient or relocate the receiver antenna

* Increase the separation between the equipment

and the receiver

* Connect the equipment into an outlet that is different from

that to which the receiver is connected

* Consult the dealer or an experienced radio/television

technician for help

The user is cautioned that changes and modifications made to the

equipment without the approval of the manufacturer could void

the user’s authority to operate his equipment.

FCC Authorization Label

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

FCC ID #:

Home Producer 8:

MG3N868629

Command Center: MG3-15-1925R

The Command Center also includes an additional IR

signal extension cord for use with a component that

is not in direct line-of-sight of the Command Center.

If you have a component that is not in the line-of-

sight of the Command Center:

1 Plug the 4 ft. IR signal extension cord into

the back of the Command Center.

2 Run the IR signal extension cord to the

component that is not in the line-of-sight of

the Command Center.

3 Using the supplied double-sided tape, attach

the IR signal extension cord so that the LED

is over or next to the IR sensor of your home

theater component.

4 Test the

Home Producer 8.

The Command

Center will convert the RF signal from the

Home Producer 8

into and IR signal and

transmit that signal to your component

through the IR signal extension cord.

NOTE: If the IR signal extension cord does not

control the component that is not in the line-of-sight

of the Command Center, reposition the LED until the

component is able to be controlled, then re-attach

the LED.

LED

SPECIFICATIONS

Remote Power ..................................................... 4 AAA Batteries

RF Command Console Power ................................. 120 Volts AC

Remote to RF Command Console Range .... 100 Feet (30.48m)

RF Command Console to Device Range .... 25 Feet (7.62m) ±30˚

Remote Dimensions (HWD)........................ 9 3/8 x 2 7/8 x 1 3/8

RF Command Console

Dimensions (HWD) ............................ 1 9/16 x 5 1//16 x 4 inches

Remote Weight (without Batteries) ............................ 8 oz. (220g)

RF Command Console Weight ............................... 10.4 oz (300g)

Specifications are typical: individual units might vary.

Specifications are subject to change and improvement without

notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

One for All URC 8090 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info